User manual ROBITUSSIN DH-750

[. . . ] If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact an electrician to replace the obsolete outlet. Never plug in vaporizer without filling with water and always UNPLUG and empty the vaporizer before moving, filling, cleaning, or storing. This can cause excessive boiling and electrical overloading of your household electrical system. [. . . ] CAUTION: DO NOT PLUG IN THE VAPORIZER WITH WET HANDS AS ELECTRIC SHOCK COULD OCCUR. NOTE: If the vaporizer does not start producing steam within 25 minutes, it means that your water's mineral content is too low to allow for electrical current flow. Add a 1/4 teaspoon of baking soda per tank of water to initiate steaming action. Make sure to thoroughly mix the baking soda with the water in the base. Adding too much baking soda can cause excessive boiling and hot water spurting, which may cause burns. If the vaporizer boils excessively, spurts hot water or blows fuses without having added any chemical additives, the water mineral content is TOO HIGH. ALWAYS be sure to discard any unused water in the base before storing or refilling. USING THE MEDICINE CUP (OPTIONAL) Place medicine in the medicine cup which is located on the top of the power head. HONEYWELL ASSUMES NO RESPONSIBILITY OR LIABILITY FOR CONSEQUENCES OR DAMAGES RESULTING FROM THE USE OF MEDICATIONS IN THIS VAPORIZER. CLEANING We recommend that you clean the vaporizer DAILY by wiping all surfaces dry using a paper towel or soft sponge. The vaporizer should also be cleaned WEEKLY according to the following instructions: Cleaning involves two steps: SCALE REMOVAL and DISINFECTING. Be sure to perform these in the proper order to avoid harmful chemical interactions. To remove the heating assembly from the base: Insert the plug into the back of the heating assembly to release the safety lock (Figure 7). While holding the plug in this position, lift the heating assembly off the unit base. Empty base and rinse with clean tap water. Fig. 7 (4 liters) water. Let solution stay in the base 20 minutes, swishing every few minutes to wet all surfaces. Wet all surfaces. TROUBLESHOOTING There are no consumer serviceable parts inside the HEATING ASSEMBLY. If you experience any problem, please check the following potential problem areas before returning the vaporizer to Honeywell or to its original place of purchase. UNPLUG THE VAPORIZER BEFORE TROUBLESHOOTING. S T E P O N E : W E E K LY S C A L E R E M O VA L (Base) 1. Let solution stay in the base for 20 minutes, swishing every few minutes to wet all surfaces. With vinegar still in the base, clean all interior surfaces of the base with a soft brush or cloth to remove scale. Carefully wipe the exterior of the Heating Assembly and remove any scale buildup. Flush the base thoroughly with clean, warm water to remove scale and cleaning solution before disinfecting base. 1. Rinse Base and Heating Assembly with water until bleach smell is gone. [. . . ] Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights which vary from jurisdiction to jurisdiction. This warranty applies only to the original purchaser of this product from the original date of purchase. At its option Honeywell will repair or replace this product if it is found defective in material or workmanship. [. . . ]