User manual RL FLO-MASTER 3PC FLO-N-GO SPRAYER

[. . . ] THIS PRODUCT IS DESIGNED TO SPRAY CHEMICALS THAT MAY BE HARMFUL AND COULD CAUSE SERIOUS PERSONAL INJURY IF INHALED OR BROUGHT INTO CONTACT WITH THE USER. FAILURE TO READ AND FOLLOW OPERATING INSTRUCTIONS BEFORE USE AND/OR MISUSE OF THIS PRODUCT COULD RESULT IN EXPLOSIVE FAILURE WITH MAJOR INJURIES. · · · · · · · · · ALWAYS water test unit before using. ALWAYS READ AND FOLLOW label instructions for chemicals to be applied. [. . . ] If your sprayer has a pressure relief valve, pull up on the valve stem. To prevent ejected pump assembly and/or solution from striking and injuring you, never stand with face or body over the top of the tank when pumping or loosening pump. 8. Empty any remaining solution into a proper storage container or disposal container. If the chemical is stored in the tank, it can clog the system as it dries and can promote corrosion. After using water-based products, rinse thoroughly with water, being sure to flush out hose and flow control. After spraying solvent or oil-based products, follow chemical manufacturer's recommended cleaning procedure. To store the sprayer, hang the tank upside down with the pump removed and the flow control locked "on". MAINTENANCE AND DISASSEMBLY: be lubricated often. To open pump assembly: To keep the pump working smoothly and efficiently, the plunger u-cup seal needs to A B C D Uncsrew pump cap (B) and pull out plunger assembly (A) from cylinder (D). If the pump leaks at the tank opening: Clean or replace the cylinder gasket (C). If pump doesn't pressurize your sprayer: Lubricate the plunger cup (E) with petroleum jelly or replace. If pump won't pressurize and/or liquid gets in the pump: Clean or replace the check valve A. F. Plunger Assembly/Pump handle Pump Cap Cylinder Gasket Cylinder Assembly Plunger Cup Check Valve E F TROUBLESHOOTING: Always depressurize the sprayer, remove chemical solution, and clean the sprayer before making repairs. Replacement parts may be purchased at most RL FLOMASTER dealers, or they can be ordered from our Consumer Service Hotline at 1-800-253-4642. CAUSE: (1) Extension o-ring prevented from sealing by dirt or damage OR (2) Extension nut not screwed in all the way on the flow control. SOLUTION: (1) Clean and examine o-ring, replace if damaged OR (2) Push extension into flow control until it snaps into place. CAUSE: (1) Pump cylinder not sealed tightly into tank OR (2) Damaged cylinder gasket or o-ring. OR (2) Thoroughly clean cylinder gasket or o-ring and surrounding area then apply grease or petroleum jelly to cylinder gasket. OR (3) Replace with new gasket or o-ring. REPAIR KITS If you need repairs kits, please call our CONSUMER SERVICE HOTLINE at 1-800-253-4642, Monday through Friday 8:00 a. m. to 7:00 p. m; March 1 through August 31 10:00 a. m. [. . . ] EXCLUDES LIABILITY UNDER THIS WARRANTY FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGE. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state. [. . . ]