User manual RL FLO-MASTER 1202 AND 1215

[. . . ] THIS PRODUCT IS DESIGNED TO SPRAY CHEMICALS THAT MAY BE HARMFUL AND COULD CAUSE SERIOUS PERSONAL INJURY IF INHALED OR BROUGHT INTO CONTACT WITH THE USER. FAILURE TO READ AND FOLLOW OWNERS' MANUAL INSTRUCTIONS BEFORE USE AND/OR MISUSE OF THIS PRODUCT COULD RESULT IN EXPLOSIVE FAILURE WITH MAJOR INJURIES. ALWAYS wear long sleeve shirts, long pants, goggles, gloves and durable shoes. ALWAYS READ AND FOLLOW label instructions for the chemicals to be applied. [. . . ] To stop spraying, release the flow control lever while pulling back on the lever. To spray continuously, squeeze the flow control lever and slide forward to lock on. If your sprayer has an adjustable cone nozzle, screw it clockwise for a fine mist and counter-clockwise for a coarse stream. ALWAYS wear long sleeve shirts, long pants, goggles, gloves and durable shoes. 2 3 5 D. To release pressure from the tank, turn the tank upside down, and then squeeze the flow control lever until all the air pressure is gone. If your sprayer has a pressure relief valve, turn yellow knob clockwise until all air pressure is gone. If your sprayer is clogged and the pressure will not release using the flow control, do the following: a. While firmly pushing down on the pump handle, slowly turn counter-clockwise. If the chemical is stored in the tank, it can clog the system as it dries and destroy the seals and other components. After using water-based products, rinse thoroughly with soapy water then clean water, being sure to flush out the hose and flow control. After spraying solvent or oilbased products, follow the chemical manufacturers' recommended cleaning procedure, following up with a thorough rinsing and flushing of the sprayer, hose and flow control with soapy water then clean water. To store the sprayer, remove the complete hose assembly (hose w/siphon tube, wand, flow control) from the tank. PUMP MAINTENANCE & DISASSEMBLY To keep the pump working smoothly and efficiently, the plunger o-ring needs to be lubricated often by applying grease or petroleum jelly around the outside of the plunger o-ring. · With a flat blade screwdriver, push down on the tabs on each side of the pump. Pull up and the handle and the plunger assembly should come out of the pump cylinder. · To reassemble, insert the plunger assembly into the cylinder and snap the cap back into place. TROUBLESHOOTING Always depressurize the sprayer, remove all chemical solution and clean the sprayer before making repairs. Replacement parts may be purchased at the store where the sprayer was purchased or they can be ordered from our Customer Service Hotline at 1-800-253-4642. SOLUTION: Apply petroleum jelly or grease around outside of plunger o-ring. CAUSE: Check valve on bottom of cylinder is prevented from sealing by dirt, residue or damage. SOLUTION: (1) Tighten hose tank nut or (2) replace hose insert o-ring. [. . . ] EXCLUDES LIABILITY UNDER THIS WARRANTY FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGE. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state. IF YOU HAVE QUESTIONS OR CONCERNS, PLEASE CALL OUR CONSUMER SERVICE HOTLINE AT 1-800-253-4642 (Mon. [. . . ]