User manual RICOH MP5316DA INSTALLATION

[. . . ] half sine) Environmental dust: Class 3 million or less (3 million particles of 0. 5 micron dustper cubic foot or less) *1 Use only media tested and recommended by Ricoh. We cannot confirm that recording of data will be successful on media other than those brands tested and confirmed. Even media tested and recommended by Ricoh, if not used under optimum recording conditions, may produce read/write errors or corrupted data. [. . . ] The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface. When several (up to four) EIDE devices are connected, each drive must be set in a unique way. Master/Slave setting is determined by a jumper on the Jumper Connector. The following table shows the possible jumper settings. CS : (Cable Select) SL : (Slave) MA : (Master) Name MA (Master) SL (Slave) Function Drive set as Master (factory default) Drive set as Slave CS Drive mode set by CSEL (Cable Select) on the host IDE interface Jumper Connector 3. Insert the drive unit into the 5-inch bay horizontally, and secure it using the provided screws. Connect the 4-pin power cable from the computer's power supply to the power connector at the drive's rear panel. If there is no spare cable available in the computer, it will be necessary to purchase a splitter cable. If a sound card is present in the computer, connect the drive to the sound card with the audio cable. If the drive is not recognized on the computer, check to see if the port is enabled in the BIOS. For more detailed explanation, refer to the manual of the computer. L/R connectors Drive Primary or Secondary Sound card 8. Mother board It is not necessary to install any special device drivers. In order to ensure normal drive operation (or if the drive is not recognized by your computer), please check the following. GB Thank you for purchasing the RICOH CD-R/RW or DVD+RW/+R drive (hereafter referred to as the ('drive'). In order to ensure the drive's long lasting operating efficiency, it must be properly installed. Please follow these procedures carefully. In order to ensure normal drive operation · For Windows ME/98/95 Users - The driver is located in [control panels] - [system] - [device manager] - [CD-ROM]. 4. 0 Users - The drive is located on the IDE controller in [control panels] - [SCSI adapter] - [devices]. · For Windows 2000 and XP Users - The drive is located in [control panels] - [System] - [hardware] - [device manager]. [. . . ] Emergency Eject In some unusual situations where the drive becomes faulty or there is a power outage, you can manually remove a CD from the drive using the following method. - Never use this method to remove CD's from the drive except for emergency purposes. - The manual method mentioned here is used only for emergency purposes. [. . . ]