User manual REVOX RECONNECT M202 UPD PROTOCOL

[. . . ] M202 M-Text Protocol M202 UPD Protocol General The commands start always with the no. [. . . ] If a Start of Text (2) will be sent, the M202 switches back to the M-Link protocol. Though both protocols can be used and is therefor backward compatible. Examples: 00:IR:VOLUME_UP 32:IR:VOLUME_DOWN 20:SELECT:TUNER Increase volume of main room Decrease volume of room 8, zone 4 Select source Tuner for room 4, zone 3 Infrared Commands xx:IR:0 xx:IR:1 xx:IR:2 xx:IR:3 xx:IR:4 xx:IR:5 xx:IR:6 xx:IR:7 xx:IR:8 xx:IR:9 xx:IR:OFF xx:IR:MUTE xx:IR:VOLUME_UP xx:IR:VOLUME_DOWN xx:IR:BASS_UP xx:IR:BASS_DOWN xx:IR:TREBLE_UP Only for Multiroom amplifier M219 ­ not main room!Only for Multiroom amplifier M219 ­ not main room! 1 M202 xx:IR:TREBLE_DOWN xx:IR:BALANCE_RIGHT xx:IR:BALANCE_LEFT xx:IR:NEXT xx:IR:PREVIOUS xx:IR:NAVIGATE_UP xx:IR:NAVIGATE_DOWN xx:IR:NAVIGATE_LEFT xx:IR:NAVIGATE_RIGHT xx:IR:PLAY xx:IR:F1_RED xx:IR:F2_GREEN xx:IR:F3_YELLOW xx:IR:F4_BLUE xx:IR:PAUSE xx:IR:SCAN_DOWN xx:IR:SCAN_UP xx:IR:STOP Source Select Commands xx:SELECT:TV xx:SELECT:VIDEO1 xx:SELECT:VIDEO2 xx:SELECT:VIDEO3 xx:SELECT:VIDEO4 xx:SELECT:VIDEO5 xx:SELECT:VIDEO6 xx:SELECT:AUX1 xx:SELECT:TUNER xx:SELECT:TAPE xx:SELECT:LOCAL xx:SELECT:CD xx:SELECT:AUX2 xx:SELECT:AUX3 xx:SELECT:LIGHT xx:SELECT:LOCAL_1 xx:SELECT:LOCAL_2 xx:SELECT:LOCAL_3 Set Commands xx:SET:VOLUME:yy 00:SET:DSP_MODE:yy yy = Volume 0. . 40 yy = DSP-Mode M-Text Protocol Only for Multiroom amplifier M219 ­ not main room!Only for Multiroom amplifier M219 ­ not main room! Only for Multiroom amplifier M219 ­ not main room!Only for Multiroom amplifier M219 ­ not main room! Only for main room (00)! 04 = PRO LOGIC 05 = PL MOVIE 06 = PL MUSIC 07 = PL MATRIX 08 = DSP STEREO / PURE ANALOG 09 = DSP X-STEREO 10 = DSP SPATIAL Do not use any other DSP-Mode figures as this might lead to errors of the 5. 1 Decoder module. [. . . ] of Playlist Error message xx:OK: xx:ERROR:COMMAND: xx:ERROR:ROOM: xx:ERROR:SYNTAX: xx:ERROR:VALUE: xx:ERROR:NOT_APPLICABLE: Command executed Unknown command Room number not valid Missing parameter Parameter not valid Command not applicable for this room Status message xx:STATUS:ROOM:yy:z:aaaa:bbbb: xx = Room number yy = Volume 00. . 40 z = Power Flag (0=off, 1=on) a = Source Name, always 16 signs b = Source Info, always 16 signs Status request xx:GET_STATUS:ROOM xx:GET_STATUS:ALL xx:PARTY * * not implemented yet Request of status for a certain room xx Request of status for all rooms Activate Party Mode for a certain zone, in which room xx is located 3 [. . . ]