User manual REVEL PERFORMA PEDESTAL 22 ASSEMBLY INSTRUCTIONS

[. . . ] Performa Pedestal 22 Assembly Instructions 3 Oak Park Drive, Bedford, MA USA 01730-0413 | Tel: 781-280-0300 | Fax: 781-280-0490 | www. revelspeakers. com | 12/03 | Part No. [. . . ] Start all screws by hand before tightening with a screwdriver. Step 4: With the stand upside-down as shown below, install the spikes (from Step 1) to the bottom of the base. Thread spikes about halfway and then use a wrench or pliers to tighten the locking nuts. Turn stand upright and adjust spikes if required. Top Plate (Rear) Wire Access Hole (3) 6mm x 18mm flat head screws Lock Nut There are different size threads on each end of the tube(s). Make sure that the end attached to the top plate properly fits the 6mm x 18mm screws before attempting to tighten. It is not possible to attach the wrong end to the top plate, as the threads at the bottom end will not fit the 6mm x 18mm screws. Spike Bottom Base (1) Large Tube (2) Smaller Tubes Step 3: Place the stand upside-down and install the bottom base with three 8mm x 20mm hex cap screws using the Allen wrench (included). Step 5: Place the Revel Performa M22 loudspeaker as shown onto a carpeted surface or a soft towel. Attach the assembled stand with four 8-32 x 3/4 Phillips flat head screws. (3) 8mm x 20mm hex cap screws Bottom Base The large tube and bottom base feature wire access holes through which speaker wires can be threaded and concealed from view. [. . . ] Bottom Wire Access Hole Revel Performa Pedestal 22 (Assembled) If wires are not threaded through the tube, use the plugs to seal the wire access holes. (4) 8-32 x 3/4" flat head screws (Start All Screws By Hand Before Tightening With Screwdriver) (Front) M22 Loudspeaker Top Wire Access Hole Top Plate (Rear) [. . . ]