User manual REMOTEC HOME THEATRE MASTER 1000

[. . . ] You must replace the battery with a new one to ensure proper functioning. Do not use old and new batteries together as old batteries tend to leak. The backlight will be turned off automatically if the remote is not active for 15 seconds. Refer to the Device Code List, look up the 4-digit device code which corresponds to the brands of your A/V equipment. [. . . ] When you finish the whole device mode, press the same device mode key (e. There are in maximum of 42 squares within 3 pages which are available to be learnt for each device mode. In case you would like to learn more than 42 commands per each device, you can make use of " SHIFT " function to obtain additional 3 more pages in order to obtain additional 42 free learning spaces under " SHIFT " platform. For detail explanation of how to use the " SHIFT " function, please refer to section " 5. If you found a learned command work for your A/V equipment only occasionally, your original remote control may contain dual signals. Press and release a desired key on the HTM1000 you want to hold the command. Press and hold the corresponding key on your A/V remote control to transfer the command. The first signal has been transferred successfully and you can release the key on the A/V remote control. Press and hold the same corresponding key on your A/V remote control until the indicator will flash once and the device mode key icon (e. Repeat steps 2 to 5 of this procedure to transfer other signals if there is any. When finished, press the same device mode key again to store your setting. Warning: Entering a new preprogrammed device code will automatically erase and replace all learned commands in the chosen device mode. Your HTM1000 is factory preprogrammed to operate your TVs, VCRs, SATs, CBLs & DVDs. Due to the limited number of key, some minor functions may not be included. You may teach your remote with the original A/V remote to operate any excluded function by your choice. Besides the preprogrammed devices, you may also teach the remote to operate other infra-red controlled equipment and appliances, such as HiFi or air-conditioners, etc. Your HTM1000 can learn and reproduce up to 226 commands from other remote controls. All 5 device modes (TV, VCR, DVD, SAT, CBL) can be taught to operate additional commands:­ 1. Hold down " P+ " & " VOL­ " on the remote together simultaneously for 3 seconds until the indicator lights up. Enter the Magic Learn Code ­ 0000, the " Learn " icon will light up and your HTM1000 is ready to learn commands. Aim your A/V remote control to the HTM1000 infra-red lens on a flat surface, with 5-8 cm apart. Press and release a desired keys on the remote you want to hold the command. [. . . ] Press and hold the command if you want to setup the transmission period of the command (max. Repeat step 5 until you finish the whole program and press the same Smart key (e. ­ Do not expose your HTM1000 to dust, strong sunlight, humidity, high temperature or mechanical shock. Press " SHIFT " and choose the Smart key that you have programmed (e. [. . . ]