User manual RCA WHP150

[. . . ] No line-of-sight limitations Built-in charger in the transmitter Virtually interference free stereo quality Automatic Level Control and auto ON/OFF control. HEADPHONE RECEIVER Power Indicator On/Off Switch Charge Input Stereo Indicator Tune Volume Control 2 3 WHP150 MANUAL(1J1500 ) 6/10/99 11:28 AM Page 4 INSTALLATION OF TRANSMITTER 1) Connect the supplied AC power adapter to an electrical wall outlet. 2) Plug the AC power Adapter into the DC jack located on the rear of the transmitter. FM AM HEADPHONE STEREO JACK AUDIO INPUT LEFT Audio Cord Charge Output Jack AC/DC Adapter Audio Cord Green LED RIGHT 1/4" adapter "Y" adapter INSTALLATION OF BATTERIES 1) Open the battery compartment cover on the right side of the headphone. 2) Insert two AA size Ni-Cd rechargeable batteries with the correct polarity. Battery Door 3) Locate the audio cord connected at the back of the transmitter. [. . . ] The adjustable headband lets you adjust the length of the headphones for a comfortable fit. 4) Tune the frequency adjustment control, located on the back of the transmitter, to a mid-level setting. Just rotate the thumbwheel knob up or down and leave it set approximately in the middle of the range. 5) Adjust the tuning dial of the headphone to the frequency of the transmitter for best reception. NOTE Headphone Base You should now be able to walk freely from room to room without disruption. If disruption should occur (signal breaks up), adjust the headphones tuning control to maximize stereo reception. If you hear interference from other components, re-adjust the tuning control. Move the control on the transmitter to a different setting, then adjust the control on the headphones to match the new setting. When transmitting/receiving over long distances, the signal from the system will become weaker and the stereo indicator light will go dim. For protection of the transmitter and to save power, the transmitter will cut off automatically in about one minute when the input signal from the audio source is too weak for operation. If the signal is restored, the transmitter will work again automatically. 7 Red LED The Ni-Cd (nickel cadmium) batteries must be fully charged prior to operation. An initial charge of 24 hours is required to ensure the extended life of the Ni-Cd batteries. 6 WHP150 MANUAL(1J1500 ) 6/10/99 11:28 AM Page 8 TROUBLE SHOOTING No Sound Ensure the AC adapter is fully inserted into the AC outlet and into the power connection input on the transmitter. Ensure the TV or audio component is on and tuned to a channel with audio. The connected audio/video equipment is not playing (CD, Tape, etc. . . ). The volume of headphone is turned down, adjust the volume to an appropriate level. If not, adjust the tuning control on the headphones until the indicator light is on. You must then adjust the tuning control on the headphone until the stereo indicator light is on. [. . . ] The exchange unit is under warranty for the remainder of the original product's warranty period. This warranty excludes defects or damage due to misuse, abuse, neglect or acts of God, including but not limited to lightning damage. The foregoing represents Thomson's sole obligation under this warranty. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. [. . . ]