User manual RAYMARINE ST5000+ SAIL PILOT

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual RAYMARINE ST5000+ SAIL PILOT. We hope that this RAYMARINE ST5000+ SAIL PILOT user guide will be useful to you.


RAYMARINE ST5000+ SAIL PILOT : Download the complete user guide (2055 Ko)

Manual abstract: user guide RAYMARINE ST5000+ SAIL PILOT

Detailed instructions for use are in the User's Guide.

[. . . ] Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company. ST5000 Plus SailPilot Owner's Handbook Document number: 81136-4 Date: May 2001 Preface i SailPilot Rudder Reference Unit Boat's Electrical Distribution Panel ST5000 Plus Control Head Fluxgate Compass SeaTalk Instruments D3559-1 ii ST5000 Plus SailPilot Owner's Handbook Raymarine, as part of its commitment to continuous improvement and updating, reserves the right to make changes, without prior notice, to the equipment, equipment specifications, and the instructions contained within this handbook. To the best of our knowledge, the information contained within this handbook was correct as it went to press. A great deal of care has been taken to ensure that this handbook is as accurate as possible. [. . . ] Press standby to clear an alarm and return to hand steering, unless otherwise stated. SeaTalk failure STLK FAIL This silent alarm indicates that there is a wiring fault in the SeaTalk connection. Off course OFFCOURSE This alarm is activated when the vessel has been off course from the locked heading by more than the specified angle for more than 20 seconds (see Section 2. 3, Using Auto Mode). The alarm is cleared if the heading recovers or the course is changed, or if the operating mode is changed. Chapter 3: Advanced Operation 25 Wind shift WINDSHIFT This alarm is activated when a change in the apparent wind angle of more than 15° is detected (see Section 3. 2, Operation in Vane Mode). Large cross track error LARGE XTE This alarm is activated when the cross track error exceeds 0. 3 nm (see Section 3. 1, Operation in Track Mode). The alarm is cleared if the heading recovers or the course is changed, or if the operating mode is changed. Drive stopped DRIVESTOP This alarm is activated if: · the rudder reference transducer fails. This occurs if the weather load on helm is too high, or if the rudder position is past the preset rudder limits or the rudder end-stops. Data not received NO DATA This alarm is displayed in the following circumstances: · Compass not connected · Track mode is engaged and the vessel arrives at the last waypoint in the track · Track mode is engaged and the autopilot is not receiving SeaTalk navigation data. · Track mode is engaged and the position transducer (GPS, Loran, Decca) is receiving a low strength signal ­ this will clear as soon as the signal strength improves. · Vane mode is engaged and the autopilot has not received wind angle data for 30 seconds. The autopilot stops adjusting the heading as soon as data is lost. 26 ST5000 Plus SailPilot Owner's Handbook Waypoint advance NEXT WPT?The Waypoint Advance alarm sounds whenever the target waypoint number changes, which occurs in the following circumstances: · Automatic acquisition is selected by pressing track from Auto · Waypoint advance is requested by pressing track for 1 second in Track mode (SeaTalk Navigators only) · When the vessel arrives at the target waypoint and the navigator accepts the next waypoint · When the Man Overboard (MOB) function is activated in Track mode. When the alarm sounds, the pilot continues on its current heading, but displays the bearing to the next waypoint and the direction in which the boat will turn to take up that bearing. Check that it is safe to turn onto the new track, and press track to accept the waypoint advance. Alternatively, to cancel the alarm without accepting the waypoint advance, press standby to return to hand steering, or auto to return to Auto mode. Note: The waypoint advance will only operate on pilots receiving valid bearing to waypoint and waypoint number information. Low battery LOW BATT The Low Battery alarm sounds when the supply voltage drops below 10 V (±0. 5 V). Start the engine to recharge the battery. Watch alarm WATCH The Watch alarm is activated in Watch mode when the timer reaches 4 minutes. It is not available from Standby mode. Chapter 3: Advanced Operation 27 If you wish to set the Watch mode, the WATCH screen must be configured as one of the Data Pages for display, as described in section 5. 1. · When the timer reaches 3 minutes, the text on the display starts flashing to indicate the last minute of Watch alarm. · When the timer reaches 4 minutes, the audible Watch alarm is activated. Press auto at any time to silence the alarm and reset the timer to 4 minutes. (Pressing any other key resets the timer and performs the key's normal function). To clear Watch mode, press disp to display a different page, or press standby. Note: You cannot engage Auto mode from Watch mode ­ pressing auto only resets the Watch timer. Shallow alarm SHALLOW The Shallow alarm is activated on the ST5000 Plus if a shallow depth alarm is received via SeaTalk. · Press disp to cancel the alarm. Man overboard (MOB) If a man overboard (MOB) message is received from another instrument on the SeaTalk system, the text MOB is shown instead of the waypoint number for the XTE, DTW and BTW Data Pages. If the autopilot is operating in Track mode, the Waypoint Advance alarm will sound to notify the change in waypoint. 28 ST5000 Plus SailPilot Owner's Handbook Chapter 4: Customising the ST5000 Plus 29 Chapter 4: Customising the ST5000 Plus The ST5000 Plus provides setup and configuration options that are used to adjust the settings for the ST5000 Plus itself, the compass, and the autopilot. [. . . ] The display shows a series of stationary dashes · Data is not being received ­ check the cabling. The display shows "NO DATA" · The signals received from the navigator are too weak ­ refer to the navigator handbook for further action. · Wind trim data is not available ­ check the connection to the wind transducer. Index 75 Index A Advice 71 Alarms 24 Apparent wind angle Adjusting 20 Previous 21 Auto mode 5 AutoAdapt 39 Automatic Deadband 23 Automatic track acquisition AutoSeastate 23 AutoTack 7 Default angle 38 Vane mode 22 AutoTrim Default setting 38 B Bar graph C Cabling 71 Calibration 29­40 Calibration lock 36 Changing course 6 Compass alignment 66 Compass deviation correction 31, 63 Course changes 6 operating hints 9 Cross track error (XTE) 16 Cruise speed 40 Customising the autopilot 29­40 D Data Pages 11 Setting up 32 Deadband 23 Dealer Setup 34­40 Depth alarm 27 Deviation display 31 Disengaging the autopilot 4 14 5 76 Display layout 4 Dodging obstacles Auto mode 6 Track mode 18 Vane mode 21 Drive Stopped alarm 25 Drive type 39 E Engaging the autopilot F Fault finding 73 Functional test 59­60 G Graph use 31 H Hand steering 5 Heading 7 Heading alignment 31 Heading alignment adjustment Heading mode 31 I Illumination 10 Installation 41­58 Interfaces 60 K Key functions 3 L Large Cross Track Error alarm LAST HDG 7 LAST WND 21 Latitude 40 Lighting 10 Low Battery alarm 26 16 5 ST5000 Plus SailPilot Owner's Handbook 67 Index M Maintenance 71 Man Overboard (MOB) 27 Manual steering 5 Manual track acquisition 15 Minimum Deadband 23 N Navigation data displays 11 Navigation interface (GPS, Decca, Loran) NEXT WPT 26 No Data alarm 25 O Off Course alarm 8 Default angle 38 Operating modes 1 Operating sense 60 P Performance 23 Pilot type 36 Previous heading 7 R Response level 23 Default setting 37 Rudder bar 31 Rudder damping 40 Rudder gain 24, 37, 67 Rudder offset 37 S Sea trial 62 SeaTalk data displays 11 SeaTalk interface 61 Servicing 71 Setup 29­40 Shallow alarm 27 Standby mode 5 Steering bar 31 Swinging the compass 63 60 77 78 T Testing autopilot operation 67 Testing the system 59­60 Tidal stream compensation 16 Track acquisition 13 Track mode 13­14 Turn limit 37 U User Setup V Vane mode 19­20 Variation 39 W Watch alarm 26 Waypoint arrival and advance 17 Wind Shift alarm 21 Wind transducer interface 61 WindTrim 19­20 29 ST5000 Plus SailPilot Owner's Handbook Surface mount template Drill 5mm (3/16in) Machine hole 90mm (3. 54in) diameter Drill 5mm (3/16in) D3441-2a Flush Mount Template TOP 4 holes 6 mm diameter Shaded area to be removed 114 mm 109 mm D4437-2 RUDDER POSITIONED AMIDSHIPS DRILL THREE 3MM (1/8IN) HOLES CABLE POSITION D3440-1 Limited Warranty Certificate Raymarine warrants each new Light Marine/Dealer Distributor Product to be of good materials and workmanship, and will repair or exchange any parts proven to be defective in material and workmanship under normal use for a period of 2 years/24 months from date of sale to end user, except as provided below. Defects will be corrected by Raymarine or an authorized Raymarine dealer. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE RAYMARINE ST5000+ SAIL PILOT




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual RAYMARINE ST5000+ SAIL PILOT will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.