User manual RAYMARINE ST2000+ QUICK REFERENCE CARDS

[. . . ] [. . . ] The names Raytheon and RTN are owned by the Raytheon Company. ST1000+ and ST2000+ Quick Reference Guide Basic operation Auto mode Extending/retracting the pushrod Course changes to port Use any of these keys to extend or retract the pushrod or Making course changes 1° or or 10° Course changes to starboard Returning to previous locked heading 1 sec then again to accept heading Entering Auto mode (Engaging the autopilot) Returning to Standby (Disengaging the autopilot) Track mode Entering Track mode (from Auto or Wind Vane mode) and WindTrim mode Entering WindTrim mode and to enter Track mode Press standby or auto to exit WindTrim mode. and Using AutoTack to accept new heading AutoTack to port (100°) and and then Press standby or auto to exit. AutoTack to starboard (100°) Autopilot displays Displaying navigation data (from Auto or Standby modes) and Switching lighting on/off (from Standby mode only) Press and Switching AutoSeastate on/off (from Auto/Track/WindTrim modes) Press and to to switch between: ON switch between: ON OFF Press -1 and +10 together to exit. Wait 10 sec to return to previous mode. OFF D3364-2 ST1000+ and ST2000+ Quick Reference Guide Compass calibration 1 Enter compass calibration Start turning boat (see 2 below) 1 sec 2 Turn boat in slow circles Turn the boat in slow circles so: · boat's speed stays below 2 knots · each circle takes at least 3 minutes 11/2 ­ 2 circles 3 Autopilot displays amount of deviation detected Keep turning the boat until the display alternates between: · autopilot heading · deviation detected 4 Align the autopilot heading Adjust the autopilot heading to match the boat's steering compass Autopilot heading or or Autopilot heading Steering compass Known heading 5 Save changes To: · save deviation correction · save heading alignment · return to STANDBY mode To: · quit compass calibration without saving 1 sec D3363-2 Document number: 86022-2 (use with handbook: 81130) Date: June 2001 [. . . ] [. . . ]