User manual RANE PR 2

[. . . ] DATA SHEET / MANUAL ZR 1 & PR 2 COMMERCIAL PROCESSOR REMOTES CP 64 & CP 52 CONNECTIONS Turn the power to the CP unit OFF until all connections are made. EUROBLOCK CONNECTIONS When wiring to Euroblocks, a minimum wire gauge of 22 is preferred for reliability. If the ground or shield wire is left shorter, it acts as a strain relief for the other wires. [. . . ] The ZR 1 remote provides Zone Level and Source Selection, allowing local control from inside the zone. If only one of the two controls is used, you may cover the unused control with one of the hole plugs provided in the kit. If you require one ZR 1 remote to control both Zones, simply wire the ports in parallel. If only one of the two controls is wired in parallel, the other is still available for a second remote. When paralleling one remote across multiple CP 64s, all three control pins must be wired, including the shields. Power to the CP 64 or CP 52 should be off until all connections are made. It is important to ensure that the Remote Ports are not subjected to sustained voltages outside the range of 0 to 5 volts DC or high levels of static. It is a good idea to install the wiring, connect it to the remote assemblies and then make the final connections at the CP unit. These pins are current limited, however, excess heat is generated in the 5 volt supply if a short occurs. Never subject the Vr1 or Vr2 pins to voltages above 5 volts. L1 L2 L3 P PROGRAM SELECT 4 2 0 6 8 10 LEVEL OFF Z1 Z2 BOTH PAGE 1 ASSIGN OFF Z1 Z2 BOTH PAGE 2 ASSIGN REMOTE MOUNTING The ZR 1 and PR 2 remote assemblies mount in a standard U. S. Be sure to note the wire color of each input in order to facilitate correct wiring to the CP unit. Connect each wire to the 5-pin connector by fully inserting it in the correct socket and tightening the screw. Make sure wires are free of nicks and that the cable jacket is stripped back sufficiently to allow it to lie in the electrical box with the remote assembly inserted. Use the flat head #6 screws supplied with the kit to mount the remote assembly and silk-screened front panel to the electrical box (see above diagram). [. . . ] #7606 ALPHA Communication and control cable: Multiconductor, unshielded CAT. # 88723 S1B 10 J1A D1 D0 1 2 3 CW 3 9 8 7 6 GND 4 3 2 1 GND S1A 5 Vc Vr 4 5 2 1 GND R1 2KRD 5 POS TERM ZONE REMOTE (ZR 1) S2B 10 J1A Z2 5 4 3 GND Z1 2 1 10 5 5 S2A 9 8 7 6 GND 4 3 2 1 GND 4 3 2 1 GND 9 8 7 6 GND PAGE 1 Z1 GND S1A PAGE 2 Z2 S1B 5 POS TERM PAGE REMOTE (PR 2) ©Rane Corporation 10802 47th Ave. W. , Mukilteo WA 98275-5098 TEL 425-355-6000 FAX 425-347-7757 WEB www. rane. com All features & specifications subject to change without notice. [. . . ]