User manual RANE CP 52S

[. . . ] EXPAND OUTPUT Wire the EXPAND OUTPUT Euroblock as required to a mono feed delivering PAGE-only, PROGRAM-only or ZONE (both) signal depending on the switch setting. This Output uses a cross-coupled line driver and may be used balanced or unbalanced. ZONE OUTPUT The ZONE OUTPUT uses a cross-coupled line driver and may be used balanced or unbalanced. ZR 1 REMOTE You may use one ZR 1 Remote (sold separately) with the CP 52S. [. . . ] 9 EXPAND LEVEL trim adjusts the signal level delivered to the ZONE EXPAND OUTPUT. 0 EXPAND SOURCE switch assigns PAGE-only, PROGRAM-only or full ZONE (both) as the source for the Expand Output. q EXPAND OUTPUT features a balanced line driver with a Euroblock connector. This mono Output may be wired balanced or unbalanced per the instructions in CP 52S Audio Connections on page Manual-4. w ZONE MONO switch, when pressed in, sums the left and right signals to provide a mono Zone signal available at both Left and Right Outputs. e ZONE OUTPUT Port features a balanced line driver with a Euroblock connector. These Left and Right Outputs may be wired balanced or unbalanced per the instructions in CP 52S Audio Connections on page Manual-4. r ZONE REMOTE Port provides the wiring interface for the optional ZR 1 wired remote. The ZR 1 remote provides remote control of Zone Level and Zone Program Select functions. t Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. Do not lift the ground connection! Manual-3 CP 52S Audio Connections All Input and Output connections are made with Euroblock connectors except for the RCA Program Inputs. When wiring to Euroblocks, a minimum wire gauge of 22 is preferred for reliability. If the ground or shield wire is left shorter, it acts as a strain relief for the other wires. Cable with a flexible jacket is easier to use and less likely to damage the connections. Fully insert each wire in the appropriate socket and tighten the screw. The Page Input is a true instrumentation amplifier and operates balanced or unbalanced. Expand and Zone Outputs are driven by high quality cross-coupled line drivers and operate balanced or unbalanced. Balanced wiring is logical, (+) to (+), (­) to (­) and shield to shield. For unbalanced operation, we recommend using two conductor cable with shield. At the other end of the cable, connect the (+) wire to signal "hot, " and both the (­) and shield wires to ground (important). If you use single conductor cable with shield, connect the shield/gnd wire to both the (­) and shield pins at the CP 52S. At the other end of the cable connect the (+) wire to the signal "hot" and the shield/gnd wire to ground. [. . . ] Set the Paging LIMIT THRESHOLD to limit the maximum Page level to the loudest desired volume. With an active Program source playing, speak into the Page mic and adjust the DUCKER DEPTH to the desired level of Program during a Page. If an automatic Program Priority override is not required, set this switch to OFF. The front panel PROGRAM SELECT switch will select the "P" Program Input just like any other nonpriority Input. [. . . ]