User manual RANE AVA 22D

[. . . ] The current Memory is indicated by the lit MEMORY LED for each Channel. Both Channel's current Delay values are stored with each press of the STORE button. The broadcast Mode (NTSC or PAL/ SECAM) is also stored with the Delay value. Each press of this button alternately recalls stored Memories (A then B then A. . . ). [. . . ] In this mode all front panel controls, with the exception of the RECALL buttons, are disabled. Press a RECALL button while in LOCKOUT to temporarily display, but not Recall, the value of the other stored Memory for the given Channel. (See Operating Instructions for optional Bypass Lockout mode. ) REMOTE RECALL & BYPASS terminals: Wiring external configuration switches to these terminals allows remote stereo bypassing or stereo memory recalling of the two nonvolatile memories. These terminals use CMOS (+5 volt) logic levels and source only 0. 5 mA (max) each. POWER connector: No, this is not where commissioner Gordon plugs in his Bat-phone, in fact it is not a telephone jack at all. Use only a model RS 1, RAP 10 or other remote AC power supply approved by Rane. The AVA 22d is supplied with a remote power supply suitable for connection to this jack. Chassis ground point: A #6-32 screw and toothed washer is provided for chassis ground. Since the AVA 22d does not get chassis ground through the AC cord, this point is provided if your system does not have another earth ground such as the rack rails. FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following: 1. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician. CANADIAN EMC NOTICE This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet Appariel numerique de la classe B respecte toutes les exigences du Reglement sur le material broilleur du Canada. CHASSIS GROUNDING If after hooking up your system it exhibits excessive hum or buzzing, there is an incompatibility in the grounding configuration between units. Try combinations of lifting grounds on units supplied with ground lift switches (or links). Some units with outboard power supplies do not ground the chassis through the line cord. Make sure these units are solidly grounded by tying the Chassis Ground Point to known earth ground. Use a star washer to guarantee proper contact. Manual-3 AVA 22d CONNECTION When connecting the AVA 22d to other components in your system for the first time, leave the power supply for last. This gives you a chance to make mistakes and correct them before any damage is done to your fragile speakers, headphones, ears, or brains. [. . . ] SENSITIVITY SETUP The first step is to apply signal and adjust the Sensitivity controls. If you know the nominal level, adjust the control indicator to that level. Otherwise, set the Sensitivity control so high signal peaks just illuminate the CLIP LED, then back off a little. ADJUSTING CURRENT DELAY VALUE One Channel at a time: With the LINK LED off, press the up/down buttons for the Channel you want to adjust until the desired Delay value is reached. [. . . ]