User manual RAMSEY W9GR
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual RAMSEY W9GR. We hope that this RAMSEY W9GR user guide will be useful to you.
 |
Manual abstract: user guide RAMSEY W9GR
Detailed instructions for use are in the User's Guide.
[. . . ] W9GR-DSPII Errata: Your W9GR kit has had a modification made to it to allow the kit to fit properly in the matching case. Two places were cut out on the front of the PC board making it necessary for you to solder in a wire jumper to connect the ground trace that was cut. [. . . ] The easiest place to do this is on the left front of the PC board next to S1. You will note the ground trace running around the top side of the board to the point where it was cut out (under each of the two pushbutton switches). Next to S1, on the left side of the board when the front panel controls are facing you, is a set of 6 holes labeled "S4", and the ground trace runs to a plated through hole at that point. You need to run the included insulated wire jumper on the solder side of the board from that hole to the ground pin on S3. This is the rightmost pin when you're looking at the front of the unit. We're sorry for any inconvenience and hope you enjoy your new kit. And once again, thanks from the folks at Ramsey!
W9GR-DSPII Errata: Your W9GR kit has had a modification made to it to allow the kit to fit properly in the matching case. Two places were cut out on the front of the PC board making it necessary for you to solder in a wire jumper to connect the ground trace that was cut. The easiest place to do this is on the left front of the PC board next to S1. You will note the ground trace running around the top side of the board to the point where it was cut out (under each of the two pushbutton switches). Next to S1, on the left side of the board when the front panel controls are facing you, is a set of 6 holes labeled "S4", and the ground trace runs to a plated through hole at that point. You need to run the included insulated wire jumper on the solder side of the board from that hole to the ground pin on S3. This is the rightmost pin when you're looking at the front of the unit. We're sorry for any inconvenience and hope you enjoy your new kit. [. . . ] This is the rightmost pin when you're looking at the front of the unit. We're sorry for any inconvenience and hope you enjoy your new kit. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE RAMSEY W9GR
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual RAMSEY W9GR will begin.