User manual RADIOSHACK 4-IN-1 FAMILY FAVORITES REMOTE

[. . . ] To use another unused device key, substitute the desired key for the VCR key in step 3. To clear a reassigned mode and reset it to its original device type, perform steps 1 and 2 above, then press the mode to be cleared twice. Switch the TV's, VCR's, SAT's, or DVD's input to view TV or video programs, or to act as your cable box's A/B switch. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] NOTE: If you try entering more than 10 channels, or if more than 10 seconds elapse between key presses, the remote automatically exits programming mode. NOTE: If your device requires you to press Enter after channel numbers, press Enter after you enter the channel numbers you want to program. To exit programming with less than 10 channels, press and hold P for three seconds. NOTE: If you have entered less than 10 favorite channels and wish to add more, you will need to reenter all of the channels. NOTE: If you have programmed 10 favorite channels, you will need to reset the remote to program new channels. Your remote lets you control up to four home entertainment devices with one easyto-use, compact unit. You can set up different groups of family favorite channels--one for Mom, one for Dad, and one for the kids. After installing batteries (see next section), you can immediately use the RadioShack 4-1 Family Favorites Remote to control an RCA TV, VCR, and DVD player, and a RCA Satellite receiver. For a DVD player, use +100 to access chapters over 10 (for example, +100, 3 = 13). Input channel number entries on some TV models or make a selection on a device's menu. Control your VCR, PVR, DVD player, or Video On Demand (VOD) if available on your cable/satellite service. Enter 9 9 3 and then press the mode key for the device you want to control volume (for example, TV). Now when you press VOL+, VOL-, or Mute, the selected device (for example, TV) will control the volume regardless of the current mode. After performing Global Volume Lock (above), press and hold P until the red LED blinks twice, then release. Press the mode key for the device you want to have independent volume control. Repeat steps 1 to 3 for any other device that you want to have independent volume control. The RadioShack 4-1 Family Favorites Remote comes pre-programmed to operate an RCA TV, VCR, DVD player, and Satellite receiver. To control devices other than those default brands, follow these steps; otherwise, skip this section. Before proceeding, find the codes for the devices you want to program in Manufacturer's Codes and write them down or highlight them. If you have a VCR/DVD combo, you may need to set up both a VCR and DVD code. Turn on the device (for example, DVD player) and, if needed, load media (for example, a DVD). NOTE: If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again. [. . . ] NOTE: If you have entered less than three channels and wish to add more, you must re-enter all of the channels for the selected user and genre. To clear a genre key, follow steps 1-6 above, but do not enter a mode or channel at step 5. â· Use and store the remote only in normal temperature environments. Modifying or tampering with the internal parts can cause damage and invalidate the warranty. [. . . ]