User manual QUANTUM SUPERLOADER 3

[. . . ] User's Guide User's Guide User's Guide User's Guide User's Guide User's Guide User's Guide SuperLoaderTM 3 SuperLoader 3 81-81317-07 B01 Quantum SuperLoader 3 User's Guide, 81-81317-07 B01, June 2010. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. Making copies or adaptations without prior written authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of the law. [. . . ] When you have advanced through all of the digits of the gateway address, the autoloader displays Enter to save. Note: If you make a mistake, press Escape to backspace to the digit you want to change. 6 Press Escape or Enter to return to the Ethernet submenu. System Time The system time is displayed by On-board Remote Management and it is used internally when logging events and errors. For example, POC: 00121, POH: 00002:07:45 where POC is the number of times the system has booted since it was manufactured, and POH is the number of hours, minutes, and seconds since the last system boot. If regular time is known, it will be used, otherwise power-on time is used. Setting the Time Zone To set the time zone: 1 From the main menu, scroll to Configuration, and then press Enter. 3 From the Time submenu, scroll to Set Timezone, and then press Enter. 4 Scroll to set the number of hours difference between your local time and Greenwich Mean Time (GMT). 5 Scroll to set the number of minutes difference between your local time and GMT, then press Enter. The new time zone is set. Quantum SuperLoader 3 User's Guide 69 Chapter 5 Administration Setting the Change Mode 6 Press Escape or Enter as necessary to return to the main menu. Setting the Date and Time To set the date and time: 1 From the main menu, scroll to Configuration, and then press Enter. 3 From the Time submenu, scroll to Set Date/Time, and then press Enter. At each position of the year, use the up and down arrows to change the value of each digit. At each position of the month, use the up and down arrows to change the value of each digit. At each position of the day, use the up and down arrows to change the value of each digit. At each position of the hour, use the up and down arrows to change the value of each digit. At each position of the minute, use the up and down arrows to change the value of each digit. 10 Press Escape as necessary to return to the main menu. Setting the Change Mode You can set the autoloader to either Random or Sequential. The default change mode is Random. 70 Quantum SuperLoader 3 User's Guide Chapter 5 Administration Setting the Change Mode In Random mode, you, or the backup software, can specify which cartridge you want to use and where you want it to go. The Sequential mode supports certain backup applications that do not manage media. During backup, when one cartridge is read or written to the end of the tape, the autoloader automatically returns that cartridge to its slot and loads the cartridge from the next higher numbered slot to the tape drive to be read or written to. The autoloader does not move the media until the host requests the tape drive to unload the tape via a SCSI unload command. Note: In Sequential mode, the medium changer does not appear in the Device Manager. The medium changer will reappear in Device Manager if you return the system to Random mode. [. . . ] SNTP is specified by RFC2030. soft error A faulty data reading that does not recur if the same data is reread from the disk or corrected by ECC. stacker A tape automation system that sequentially loads and unloads tape cartridges. does not provide random access to cartridges of the data stored on them. stepper A type of motor that moves in discrete amounts with each electrical pulse. [. . . ]