User manual QUANTUM STT220000A

[. . . ] TAPESTOR® EASY INSTALLATION SHEET GETTING STARTED To install your new TapeStor Travan 20GB tape drive, follow the simple steps listed below. For detailed installation instructions and trouble-shooting tips, see the online manual on the Tape Resource CD. [. . . ] The CD will startup automatically on most Windows systems (if it doesn't autostart, run setup. bat from the CD). From the introductory screen, click on "Installing Your Drive. " Linux users can find the manual in the /pdfs directory of the CD under the appropriate language. Before continuing to the next step, shut down your computer, turn off the power, and remove the cover. STEP 2 Master Slave (default) Cable select Step 2: Configure the drive (optional) If your tape drive will be on the same cable with an existing ATAPI device (such as a CD-ROM), you do not have to change the default jumper setting (tape drive is a "slave"). Make sure that the existing ATAPI device is the "Master. " If your tape drive will be the only device on your secondary IDE port, you need to configure your tape drive as a "Master. " Turn the drive over and move the master/slave jumper to the "Master" position, as shown at left. Step 3: Mount the drive a) If you are mounting the tape drive in a 3. 5-inch drive bay, skip to step 3b below. If you are mounting the drive in a 5. 25-inch drive bay, attach mounting brackets to each side of the drive, as shown at far left. 3a STEP 3 3b 5. 25-inch drive bay 3. 5-inch drive bay b) Slide the drive into an unused drive bay until the bezel is flush with the front of the computer. Do not overtighten the screws. Step 4: Connect the IDE cable Attach your tape drive to the secondary IDE port. Do not attach your tape drive to any cable that is already connected to a hard drive, a floppy drive or a sound card. If no drives or cables are attached to your secondary IDE port, you may need to purchase a new 40-pin IDE cable to run from the secondary IDE port to your tape drive. Attach the new IDE cable to the secondary port and to the tape drive as shown in the illustration 4a. If you already have a CD-ROM or other device attached to your secondary IDE port, attach the tape drive to the middle connector on the IDE cable, as shown in illustration 4b. 4a d aarr H ivve H rr D D 4b dd ar H iivee r D r te rd pu a m rbo Co the o M Note. When attaching cables, Make sure that pin 1 on the drive is connected with pin 1 on the IDE connector. Pin 1 on the IDE cable is indicated by a stripe on the edge of the cable. STEP 4 r te rd pu oa om erb C th o M Step 5: Connect the power cable Connect a 4-pin power cable to the back of the tape drive. [. . . ] Certance reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission from Certance LLC. [. . . ]