User manual QUANTUM QKM INSTALLATION REV A

[. . . ] Plan the device installation starting from the bottom of the rack cabinet. Do not leave open space above or below an installed server in your rack cabinet. To help prevent damage to server components, always install a filler panel to cover the open space and to help ensure proper air circulation. Do not extend more than one device out of the rack cabinet at the same time. [. . . ] See Figure 2. Tab 1 Tab 2 Figure 2 Rail-Adjustment Bracket Rail-adjustment bracket 2 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 2 Lift the release tab and fully extend the rail-adjustment bracket from the rear of the slide rail until it snaps into place, if you need to adjust the slide-rail length. Align the pins on the rear rail-locking carrier with the holes on the rear mounting flange. Then, press tab 2 to secure the rear of the slide rail to the rear mounting flange. slide rail. Important: Ensure that the pins are fully extended through the mounting flange and Figure 3 Securing the Slide Rail to the Rear Mounting Flange Tab 2 Release tab Pins extended through the mounting flange and slide rail Pins not extended through the mounting flange and slide rail 3 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 3 Align the pins on the front rail-locking carrier to the front mounting flange. If you adjusted the rail length, push the rail-locking carrier back toward the rear of the slide rail to align the slide rail with the mounting flange. Then, press tab 2 to secure the front of the slide rail to the front mounting flange. See Figure 4. Important: Ensure that the pins are fully extended through the mounting flange and the slide rail. Repeat step 1 and step 2 for the other slide rail. Figure 4 Securing the Slide Rail to the Front Mounting Flange Mounting flange Tab 2 Pins extended through the mounting flange and slide rail Pins Pins not extended through the mounting flange and slide rail 4 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 4 Transporting the rack cabinet with the server installed. If you do not plan to transport the rack cabinet to another location with the server installed, skip this step. If you plan to transport the rack cabinet to another location with the server installed, remove the large screw and discard it. Then, fully extend the rail and insert the screw you saved into the position where the large screw had been located. Repeat this step for the other rail. Figure 5 Securing the Rail for Transport Rail screws Front screw Large screw 5 Quantum Key Manager Rack Installation Document 6-66533-01 Rev. A May 2009 5 Align the server on the slide rails and push the server fully into the rack cabinet. Secure the server to the front mounting flanges with the captive thumbscrews. Note: You must leave the shipping brackets attached to the slide rails unless the shipping brackets impede the server from sliding fully in the rack cabinet. [. . . ] Go to steps 4, 5, and 6 for instructions. Figure 9 Securing the Server to the Rack for Transport Made in the USA. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. Making copies or adaptations without prior written authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of the law. [. . . ]