User manual QUANTUM PX502 QUICK START GUIDE 81-81292-01 D01

[. . . ] Quantum PX502 Tape Library Quick Start This Quick Start Guide explains how to: · Install the Quantum PX502 library · Cable the library · Complete the installation All of the user documentation for the Quantum PX502 library is available in electronic format on the Quantum PX500 Series Documentation CD included in the library accessory kit. Note: The electronic documents are in Portable Document Format (. PDF). Required Tools: · 3mm Allen® wrench (included in the accessory kit) · 2. 5 mm Allen wrench (included in the accessory kit) · Flat blade screwdriver (not included) STEP 1: INSTALLING THE LIBRARY This section explains how to install a PX502 library in a standard 19 inch rack. [. . . ] Assemble the rack mount shelves (see figure 1): · loosely attaching the adjustable shelf with four Allen screws (with T-nuts) · install the appropriate rail adapter to the front and back of the rack mount shelves. The rail adapters are keyed for either square or round (threaded and unthreaded) rack rail patterns. The back mounting brackets are lettered (A through I) so the correct mounting position is easily located (see figure 3). rack (front rail to back rail) to determine the back mounting orientation. Figure 1 Assembling the Rack Mount Shelves Rail adapter T-nuts Screws T-nuts Rail adapter Rail adapter Screws · >27 to 29 in. use G and I Figure 3 Installing the Back Mounting Brackets Slots Once the location is determined, attach the back brackets to the library with two Allen screws on each side of the library. The slots face the back of the library. The Flexlink opening on the right-hand shelf is towards the back Screws Screws The FlexLink opening on the left-hand shelf is towards the front Quantum PX502 Tape Library Quantum PX500 Series Quick Start, 81-81292-01 C01, June 2005, Made in USA. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. Making copies or adaptations without prior written authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of the law. TRADEMARK STATEMENT DLT, SDLT, DLTtape III, DLTtape IV and Super DLTtape I are all trademarks of Quantum Corporation. Other trademarks may be mentioned herein which belong to other companies. 5. Install the library into the rack as shown in figure 5 and secure the front of the library to the rack with two screws on each side. Figure 5 Installing the Library into the Rack STEP 2: CABLING THE LIBRARY To cable the library: 1. Install the tape drives in the drive bays located on the back of the library and secure by tightening the captive screws with a flat blade screw driver (see figure 7). For additional information on tape drive installation, see the Quantum Tape Drive Installation Instructions (PN 81-81301-01) included on the documentation CD. [. . . ] Secure the back of the library to the rack with two clamps and two screws on each clamp. The clamps are oriented differently depending on the depth of the rack. short portion mounted to the front Figure 6 Installing the Back Clamps Figure 7 Cabling the PX502 Local network Host connection System control board Captive screws Long portion Captive screw Power connector Terminator Captive screw SCSI jumper cables To complete the installation, refer to the Quantum PX500 Series User's Guide PN 81-81290 for information on installing tape cartridges and initially configuring the library. STEP 3: Completing the Installation [. . . ]