User manual QUANTUM INST GUIDE CD72LW1U UPGRADE

[. . . ] Installing a Second Drive in the 1U System Required tools: #1 and #2 Phillips Head screwdrivers Inventory of Components: (1) DAT 72 Tape Drive (1) IO adapter bracket, with an internal SCSI cable, SCSI ID switch, and a SCSI ID cable attached (2) Drive tab mount brackets (2) M3 x 0. 5 flathead Phillips screws for drive tab mounts (6) Wire ties to secure the cables to the 1U chassis 1. [. . . ] Insert the tabs on the drive tab mounts into the mounting holes on the second drive (Figure 3A). While holding the drive tab mounts against the drive, position the drive tab mounts over the retaining holes in the drive bay (Figure 3B). Figure 3C Figure 3D Insert the second drive into the drive bay, sliding the drive tab mounts into the retaining holes on each side of the drive bay (Figure 3C). Once the holes on the drive bay are lined up with the holes on the drive tab mounts, the front of the drive should be flush with the front panel of the system. Secure the drive tab mounts to the system with a #1 Phillips Head screwdriver and the two screws provided (Figure 3D). Purple Wire I/O Bracket Figure 4B Bulkhead Opening 6. Route the SCSI and SCSI ID cables through the opening in the bulkhead to the back of the second drive. Connect the SCSI ID cable into the second drive's SCSI ID connector (Figure 4A). Orient the SCSI selector cable so its purple wire is visible and against the power connector. Insert the power connector from the power source into the power input of the second drive (Figure 4B). [. . . ] Connect the power cord to the power receptacle on the back left side of the system (Figure 5). [. . . ]