User manual QUANTUM HP900 S800 UXV9 CONFIG

[. . . ] Quantum Corporation DLTtapeTM Application Note _____________________________________________________________________________________________ DLTtapeTM Installation HP® 9000 Series 800 System HP-UX® 9. 04 This application note is to be used only as a guideline for the titled subject. The user assumes all responsibility for understanding the interrelationships of this information with other affected software or system products. [. . . ] HP-UX, however, will not recognize these models, but instead, will attempt to apply generic tape drive parameters. This may limit drive performance and these models are not supported with HP-UX fbackup/frecover command in this version of HP-UX. The following section describes how to install a DLTtape tape peripheral on an HP9000/800 system running HP-UX 9. 04. This note assumes that the DLTtape tape peripheral you are installing conforms to the SCSI-2 standard. Installation Instructions will cover the installation of the DLT tape peripheral hardware and configuration of the system to communicate with the DLT tape peripheral. The installation requires a patch that you obtain from Hewlett-Packard be installed on your system. The patch ID and title currently is: PHKL_12056 - s800 9. 04 HP-PB SE SCSI and tape driver cumulative patch Also, if you intend to use your DLT drive with HP' fbackup/frecover utility, you will need the following s patch: PHCO_6738 - s700_800 9. X cumulative fbackup(1M) and frecover(1M) patch Using a web browser, you can download the patches from Hewlett-Packard' Electronic Support Center s web site. Note that because of the nature of HewlettPackard' patch database, patch ID' are subject to change. Before you install the patch, make sure the system has tape2tape device driver included in the kernel. This can be accomplished using HP's SAM utility. Copyright 1999-2001 Quantum Corporation or its subsidiaries or affiliates. [. . . ] Files /tmp/<PATCH>. text and /etc/newconfig/DLT. README may contain additional information regarding DLTtape device verification and use. Although the fbackup command appears to work with DLTtape tape peripherals, it should be noted that the frecover command does not. Copyright 1999-2001 Quantum Corporation or its subsidiaries or affiliates. [. . . ]