User manual QUANTUM CL400

[. . . ] Device Application Notes For NetVault 6 Revision A7-1 Application Notes Product: CERTANCE ULTRIUM 2 Firmware Revision: 153R Interface: SCSI LVD/HVD Tape Drive: CERTANCE Viper 400 LTO-2 Tape Drive Key Features · Supported Media o LTO Ultrium 1 Tape Cartridge o LTO Ultrium 2 Tape Cartridge o Ultrium Cleaning Cartridge Interfaces o Wide SCSI LVD o Wide SCSI HVD o Fibre Channel Additional Features o 64 Mb on board cache o Dual internal cooling fans · · BakBone Software, Inc. 1 9/25/2003 Device Application Notes For NetVault 6 Revision A7-1 NetVault Software: Minimum Release Required · Version 6 Release: o V653_R021217 Additional Software Required · Device Template(s): o SEALT00. npk (viper200. tpl) Attention: Device Template Installation available through the use of standard package installation procedures. Refer to the following for details. BakBone Software, Inc. 2 9/25/2003 Device Application Notes For NetVault 6 Revision A7-1 Installation: Prerequisites Ensure cabling and termination is configured correctly by referring to the Manufacturer User's Guide. [. . . ] Drive Addition Within NetVault BakBone Software, Inc. 3 9/25/2003 Device Application Notes For NetVault 6 Revision A7-1 Configuration (for Optimum Performance) Select the Configure Tab, right-click the drive and select Configure, to display the Configure Device dialog box. (Refer to Figure 2 on next page. ) Click the Configuration tab in the dialog box and increase the Media block size (Kb) from the default setting of 32 Kb. Ensure your operating system and drive can support the new value entered. Click the Performance tab in the dialog box and increase the default transfer memory buffer setting from the default setting of 257 Kb. NOTE: The Amount of memory to assign to transfer buffers (Kb) is what is often referred to as the shared memory setting. The optimum figure is dependent on the drive model, and will be stated in the relevant BakBone Software Benchmark document, but the minimum value to use is at least 4x the block size setting for the drive. Ensure there is sufficient RAM (Windows NT or 2000) or Kernel Memory (UNIX). If there are more drives repeat the above steps for each drive as required. Save device configuration by selecting the "Save Details" button in the top left corner. Close the "Add Library" window. BakBone Software, Inc. 4 9/25/2003 Device Application Notes For NetVault 6 Revision A7-1 Figure 2. [. . . ] Note your operating system must be able to support this when configured. Cleaning Tape Support: Emulation Mode: NetVault 6. 5. 3 ­ Not supported at this time. [. . . ]