User manual QUANTUM ADIC SCALAR 100 QUICK START GUIDE REV A

[. . . ] ADIC® Scalar® 100 Quick Start Guide If your library configuration contains a SNC (Storage Networking Controller), the installation and set-up must be performed by ADIC-qualified personnel. 5 On the bottom-most drive, connect a jumper cable to the top SCSI connector and then to the bottom SCSI connector on the drive above it. [. . . ] For AIT libraries, install drives into slots two through five, beginning with slot two. 2 6 7 Terminate the SCSI bus(es) with an appropriate terminator (LVD or HVD). Install the cables between the bottom drive and the Library Controller and between the Library Controller and the host. If you have more than one SCSI bus, connect a cable between the bottom drive on the SCSI bus and the host. 9 10 11 Turn on the rear power switch and then turn on the front power switch. 3 Slide the drive(s) into position and tighten the two captive thumbscrews. HVD SCSI Connections SCSI Interface Switch Terminator LVD SCSI Connections Front Power Switch Filler Plate Drive Module Library Controller to Host Rear Power Switch Captive thumbscrews Library to Host 4 Depending on your host SCSI bus type, set the SCSI interface switch to LVD or HVD. 12 Optional SNC Power up your host system and verify communication with all devices on the bus. Your library is now ready. 6-00671-01 Rev A Drive to Library Controller Jumper Cable Power Cord Selected Indicators and Controls Operator Panel Information Area Explanations The information area provides general library information such as online/offline status and the date and time. * * * * * * Online/ Offline. . . Status Command Mailbox Indicator Area Drive Status Area The drive status area provides constant drive status. To make a selection, press the softkey below the button in the button area. [. . . ] For more information, see the Scalar 100 User's Guide. Your screen may differ depending on you library configuration and drive type. [. . . ]