User manual QUANTUM ADDENDUM STUX2001XX CL400LWXX

[. . . ] Do not try to use the drive until after it has been serviced. Before You Start Before you manually remove a cartridge from the drive: 1. Place the drive on a workbench with proper ESD grounding: attach a wrist strap to the bench and the other end to your wrist. (You will need a 1. 5-mm hex driver. ) NOTE: Do NOT remove the front bezel or the bottom cover from the drive. 7. [. . . ] The drive must be returned to Certance for servicing. If you have any questions about this procedure, contact Technical Support. 3 Manually Removing an LTO Cartridge Cartridge is Loaded and Seated with Tape Threaded If the cartridge is loaded and seated, and the tape is entirely or partially threaded into the drive, follow these steps. To perform these steps you will need a small, flat-blade screwdriver and a 1. 5-mm hex wrench. shows key components of the drive mechanism that are referred to in the following procedure. NOTE: Do not touch any other part of the drive mechanism except for the components specified in the instructions. The MR elements in this assembly are highly susceptible to damage from static electricity. . Worm gear Lead screw Load arm Slot in drive chassis Head assembly Take-up reel and hub Tape grabber Figure 3. Be sure the head assembly is in the lowered position by turning the lead screw (see Figure 4 on page 5Error!This is necessary to allow the load arm to clear the head assembly when it is moved back toward the cartridge. 4 Manually Removing an LTO Cartridge Figure 4. Insert the 1. 5-mm hex wrench through the hole in the bottom plate shown in Figure 5 on page 6Error!Turn the hex wrench clockwise slowly and smoothly to rewind the tape into the cartridge. This may take some time. CAUTION: If you turn the hex wrench quickly or unevenly, you may create a tape loop, which could cause tape contamination. 5 Manually Removing an LTO Cartridge Figure 5. When all of the tape has been spooled off of the take-up reel, turn the drive right side up. Rotate the hub to align the slot in the hub with the slot on the drive chassis (see Figure 3 on page 4Error!Rotate the load arm until the tape grabber clears the hub. CAUTION: Be especially careful not to touch the tape head assembly. The MR elements in this assembly are highly susceptible to damage from static electricity. 8. Take up the slack tape again using the 1. 5-mm hex wrench, as described in step 4. Carefully push the grabber in toward the cartridge, as shown in Figure 6 on page 7. 6 Manually Removing an LTO Cartridge Figure 6. When the leader pin and the tape grabber reach the cartridge, gently push the grabber toward the front of the cartridge. Use the grabber to push the leader pin gently into the cartridge until it seats in place (you should hear a click). Using a flat-blade screwdriver, pivot the white lower track toward the drive bezel to disengage the leader pin. [. . . ] Certance reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission from Certance LLC. Certance provides this document "as is, " without warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. [. . . ]