User manual QUANTUM 818126701A01

[. . . ] Quick Start Guide This Quick Start Guide contains a sequence of steps recommended for unpacking and installing a slide rail kit for the SuperLoader. For additional information, visit www. quantum. com, refer to the Quantum Superloader Automated Tape Library User Manual installed as a PDF (portable document format) file on the enclosed CD, or contact Quantum Technical Support and Customer Service by calling 1-800-284-5101. [. . . ] Identify the correct mounting holes on the vertical rail, making sure that the holes are all on the same level. SuperLoader Slide Rail Kit Installation Quick Start Guide Page 2 d. To do this, extend the slide rails on both sides and then attach the shelf to the rails. b. If you pull on the outer slide, the pieces extend, making the slide longer. From the front, mount the outer pieces of the slides into the cabinet (per previously located holes) using the screws and threaded plates. To do this: (1) Select the long or short rear-mounting slide brackets, depending on the rail-to-rail spacing in the side of the cabinet. (2) Secure the rear-mounting brackets to the slide using the screws and nuts or the treaded flat plate. This allows for adjustment while inserting the shelf assembly into the mounted slides. Shelf e. After inserting the shelf onto the rails, slide the shelf slowly in and out of the cabinet a few times (to make sure it moves freely) and then tighten all slide screws. Push the shelf all the way into the cabinet in preparation for the next step. Threaded flat plate 0. 38-inch screws Threaded flat plate 0. 38-inch screws Threaded flat plate SuperLoader Slide Rail Kit Installation Quick Start Guide Page 3 i. At the front of the cabinet, install 4 clip nuts (provided with the cabinet) so that they are level with the screw holes (two per side) in the SuperLoader mounting flanges. Use four cabinet attachment screws (provided with the cabinet) to lock the SuperLoader in place in the cabinet. Warning: To avoid injury or equipment damage, it is recommended that two persons lift the SuperLoader and place it on the slide rail shelf. At the back of the cabinet, attach the SuperLoader to the shelf using the two brackets (#74-60674-00), four short pan head screws (#10-32 x 0. 25), and four long pan head screws (#10-32 x 0. 38) as follows: Note: Make sure that you use the 0. 25-inch screws in the vertical holes, not the 0. 38-inch screws. [. . . ] Products mentioned herein are for identification purposes only and may be registered trademarks or trademarks of their respective companies. All other brand names or trademarks are the property of their respective owners. [. . . ]