User manual QUANTUM 818126601A01

[. . . ] SuperLoaderTM Bar Code Reader Upgrade Quick Start Guide This Quick Start Guide contains a sequence of steps recommended for unpacking and installing a bar code reader in the Quantum SuperLoader. Warning: The bar code reader is a Class 1 laser product, complying with 21 CFR 1040. 10 and 1040. 11. The use of controls or adjustments or the performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] Proper grounding and electrostatic discharge (ESD) handling precautions are required before removing the bar code reader from its packaging. Set the bar code reader down on the work surface. Step 2: Unmount the SuperLoader Warning: Two persons are required to lift the SuperLoader or unmount it from a rack. Before you can install the bar code reader, you must remove the right magazine or magazine blank from the SuperLoader and then remove the SuperLoader from its rack or cabinet. For instructions about removing magazines and unmounting the SuperLoader from a rack, refer to the Quantum SuperLoader User's Guide. Note: Unmounting the SuperLoader requires a #1 PHILLIPS® screwdriver. This screwdriver will also be required during the remainder of the bar code reader upgrade procedure. SuperLoader Bar Code Reader Upgrade Quick Start Guide Page 2 Step 3: Prepare the Bar Code Reader Bay a. With the SuperLoader on a flat work surface, remove the top cover of the SuperLoader as follows: (1) Remove the PHILLIPS screws (SuperLoader LTO has four screws, SuperLoader DLTTM has two screws) from the top of the SuperLoader and four PHILLIPS screws from the back. SuperLoader (with top cover removed) Screws (back) e. Gently pull up on this cable to straighten it. Flex cable Step 4: Install the Bar Code Reader Screws (top) (2) Slide the cover backwards approximately 2 inches (5. 0 cm), and then lift it off. Then, discard the foam insert. Caution: These instructions are for both the SuperLoader DLT and the SuperLoader LTO due to the nature of their similarities. Take appropriate ESD precautions including creating an antistatic work area and wearing an antistatic wrist strap and other antistatic apparel (smock, etc. ). Mirror Foam insert (being removed) Bar code reader b. Caution: Touching the mirror can cause the reader to malfunction. SuperLoader Bar Code Reader Upgrade Quick Start Guide Page 3 c. Carefully extend the strain relief mechanism on the bar code reader zero insertion force (ZIF) connector. e. Slide the bar code reader into the bay and do the following: · Make sure the washer and attached screw fit into the slot on the wall of the bar code reader bay. The top of the alignment tab on the bar code reader should be flush with the top of the bar code reader bay wall. [. . . ] DLTtape, the DLTtape logo, Quantum, the Quantum logo, SuperDLTtape, the Super DLTtape logo, and SuperLoader are trademarks of Quantum Corporation registered in the U. S. A. Products mentioned herein are for identification purposes only and may be registered trademarks or trademarks of their respective companies. All other brand names or trademarks are the property of their respective owners. [. . . ]