User manual QUANTUM 818126401A01

[. . . ] SuperLoaderTM Drive Carrier Assembly (DCA) Replacement Quick Start Guide This Quick Start Guide gives the steps for replacing the drive carrier assembly (DCA) of a Quantum SuperLoader. These instructions are for both the SuperLoader DLTTM (which includes the SuperLoader SDLT) and SuperLoader LTO due to the nature of their similarities. [. . . ] Rotate the DCA so that one foam pad is against the work surface and the other is above the DCA. Proper grounding and electrostatic discharge (ESD) handling precautions are required before removing the DCA from its packaging. These precautions include unpacking the DCA in a static-free work area and using an antistatic wrist band as well as other antistatic apparel. Set the DCA down on the work surface. Step 2: Prepare for Removal and Replacement Caution: Do not apply power to the DCA unless the DCA is fully installed in the SuperLoader and secured by all four mounting screws. Make sure you have the following tools: · #2 PHILLIPS® screwdriver b. Leave the replacement DCA in its antistatic packaging until you are ready to install it. SuperLoader Drive Carrier Assembly (DCA) Replacement Quick Start Guide Page 2 Step 3: Remove the Current DCA Note: Before you remove the DCA, make sure the tape drive does not contain a tape cartridge. For instructions about unloading a cartridge from the tape drive, refer to the User's Guide. Remove the four screws that secure the DCA to the chassis at the rear of the SuperLoader. e. Note: The DCA must be returned to Quantum in the replacement DCA packaging within 7 business days. For further information, refer to the return material authorization (RMA) instructions shipped with the replacement DCA. Step 4: Install the Replacement DCA Caution: While removing or handling the SuperLoader DLT DCA, take appropriate ESD precautions to prevent accidentally touching or damaging the exposed printed circuit board assembly on the underside of the unit. Grasp the DCA by the handle with one hand and support the underside of the DCA with the other hand. Make sure you position the DCA correctly; it should slide smoothly into the bay. [. . . ] Products mentioned herein are for identification purposes only and may be registered trademarks or trademarks of their respective companies. All other brand names or trademarks are the property of their respective owners. [. . . ]