User manual QUAD 405

[. . . ] Using polluted gasoline will cause rust inside the fuel tank, and will close the supply of fuel to the carburetor, leading to an improper engine starting or may cause serious damage to an engine. Always use genuine oil to protect and extend vehicle performance and its life span. If any failure occurs due to the use of polluted gasoline or oil, such failure will be excluded from being eligible for repairs under the warranty. Careful driving and the wearing of proper attire and safety equipment are the most important factors in the safe operation of the scooter. [. . . ] Gasoline may leak out of the fuel tank when replacing the fuel tank cap if too much gasoline is put in the fuel tank. Using it can cause damage (bending, getting worn, etc. ) to combustion chamber and parts of fuel. It may cause the damage of the cap and the rubber packing resulting in the leak of fuel and may cause fire in case of electrical short or the overturn of the vehicle. LIGHTS AND WINKER INSPECTION <HEADLIGHT, TAILLIGHT> Start the engine and make sure the lights turn on. Also check to see if the lights are damaged or if there is dirt on them. <CHECK> If the oil is low, the oil warning indicator will turn on. Turn the main switch to ON in order to check whether the oil warning indicator switches on. If it does, put oil in the oil tank. <BRAKE LIGHT CHECK> Turn the main switch to ON. While separately operating the front and rear brakes, check to see if the brake light turns on. Also check to see if there is any damage to the lens or if there is dirt on the brake light. <WINKER CHECK> Turn the main switch to ON. Check to see if all the winker in the front and rear of the vehicle(including left and right sides) are flashing properly. At the same time, check to make sure that the automatic sound signal of the winker is working. Check also to see if any of the lens are damaged or dirty. CAUTION Do not allow the engine to stay at a low level. Do not let brake fluid contact vehicle parts as this damages painted areas. Use recommended brake fluid as other types can undergo chemical changes. If brake fluid is exceedingly low, this can be indication of damage to the brake system. A leak in the brake system can lead to reduced braking efficiency and possible loss of braking ability. BRAKE HOSE, PIPE LEAKAGE, DAMAGE, ASSEMBLY STATE Visually check for fluid leaks or damage and, using a spanner, check joints and clamps for clearance. Also, check hose and pipe protective parts to see if they contact other parts when turning the handle bars or due to vibration when driving. BRAKE PAD INSPECTION Operate the brake lever to check the wear of the brake pad. While looking at the brake caliper, if the wear limit line is not visible, the pads need to be replaced. CAUTION The brake lever must be operated several times after replacement of the front brake pad. 35 REPLENISHING ENGINE OIL <INSPECTION> If the oil is low, the oil warning indicator will turn on. Turn the main switch to ON in order to check whether the oil warning indicator switches on. Check to see if the seat lock has latched. <RECOMMENDED OIL> If oil sold on markets or privately manufactured oil (oil-grade) is used, engine life is adversely affected, and the privilege of warranty repairs cannot be guaranteed. Do not use other manufacturers oil and do not use low quality oil. CAUTION Always pay attention to keep up proper oil level. Driving with the oil warning indicator turned on may cause severe damage to the engine. Sometimes, the indicator becomes inoperative due to the faulty oil warning indicator switch. [. . . ] Wrist : Keep the state to act freely without applying excessive force to the shoulder and arms. Knees : Relieve the tension and keep the distance of both knee same as shoulders. Feet : Place the feet to face the front parallel and keep the distance of both feet same as shoulders 1 2 3 4 5 6 7 49 < VEHICLE EXCEPT SCOOTER > Eyes : Look at the front direction widely. Arms : Relieve the tension and bend arms to inside and let them act as the spring. [. . . ]