User manual PYLE PWMA850

[. . . ] Handle the wireless system carefully, dropping or other shocks may cause failure. Avoid using the system where it may be subjected to heat, such as direct sunlight, near radiators or other heat sources. It may be possible to dry the system, but you should have it checked by a qualified technician before using it again. [. . . ] If damaged in any way, do not use the system and refer to a qualified technician for repair. If the wireless system is not going to be used for a while, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove the leakage with a damp cloth. Take care not to get battery electrolyte in contact with your skin, however if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately. Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation. Do not use any solvents to clean any part of the wireless system . Precautions Hand-held microphone Receiver Installation Trouble shooting Specifications 1 PARTS DESCRIPTION 6 + ON Mesh: cartridge inside Tube Power LED indicator Power and Mute switch: Switch on and off the microphone. Alternatively, you can connect an XLR cable to the XLR balanced output. Connect the mains power adaptor from "DC 12V" jack to a suitable mains power socket. away from wall MIC LINE MIC LINE MIC LINE MIC LINE MIC LINE 4 The on air indicator does not light up The wireless microphone is not turned on. The microphone receiver is not connected properly. Frequency not set correctly. Turn on the wireless microphone Turn on the microphone receiver and the connected audio equipment Turn on the microphone receiver and the connected audio equipment Make sure mic and receiver are set to the same frequency. The battery in the wireless microphone is weak. The distance between the wireless microphone and speakers are too close. The battery in the wireless microphone is weak Replace the battery. Connect the speakers/ headphones Replace the battery. No sound The sound is distorted Adjust the volume controls. Move the wireless microphone away from the speakers or change the direction of the microphone. [. . . ] The battery in the wireless microphone is weak Replace the battery. Connect the speakers/ headphones Replace the battery. No sound The sound is distorted Adjust the volume controls. Move the wireless microphone away from the speakers or change the direction of the microphone. Replace the battery. A howling noise heard from the speakers. 5 A. [. . . ]