User manual PYLE PPHP1594

[. . . ] PPHP1594 PPHP1595 OWNER'S MANUAL www pyleaudio com Contents Safety Instructions About the PPHP1594 PPHP1595 Applications Features Loudspeaker Placement and Mounting Troubleshooting Specifications Frequency Response 1 2 2 2 2 3 4 4 Safety Instructions WARNING: Do not expose this unit to rain or moisture. No user serviceable parts inside. Please refer all servicing to qualified personnel. Important Safety Instructions 1. [. . . ] Stand speakers upright for PA-Tilt the speakers back for stage monitoring. Upright stance Provides even Coverage over a wide, PPHP1594 PPHP1595 speakers ane also designed with two slanted Positions for stage monitoring applications. Loudspeaker Placement and Mounting 2 PPHP1594 PPHP1595 TROUBLESHOOTING TROUBLESHOOTING Symptom No sound Likely Cause Speaker not connected to amplifier Speaker cable is faulty or improperly connected. What to do Verify that speaker is connectedand that the amp is on Re-seat the cable at both ends. Substitute a known-good cable Signal source(mixer, instrument, etc. ) Is not sending a signal. Faulty cables and connections Check VU meters on the source mixer Verify that the tape or CD is playing. Use headphones to verify that the instrument is actually sending an audio signal Disconnect and re-seat signal cables. Replace suspected cable with a known-good cable Signal sounds distorted and very loud. Excessive input signal, trying to exceed the capabilities of the speakers Turn down the level controls on the amplifier. Use additional speakers. Signal sounds distorted even at moderate volumes. Mixer or other source is overdriven Review the Owner's Manual for your mixer and adjust controls as needed. Input sensitivity (gain) Channel faders Master faders Disconnect the devices that are connected to your speaker one at a time. If the noise goes away, the problem is with the source or the connecting cable. Noise or hiss heard at output Noisy source device Microphones are pointed into the speakers Speakers feed back and howl when the microphone volume is turned up Equalizer settings art incorrect Excessive gain Move the speakers so they do not point the microphone's pickup pattern. [. . . ] Our obligation under this warranty is limited to the repair or replacement of the defective unit when it is returned to us prepaid. This warranty will be considered void if the unit was tampered with, improperly s e rv ic e d o r s u b je c t to m is u s e , n e g le c t o r a c c id e n ta l d a m a g e . [. . . ]