User manual PYLE PLXR8

[. . . ] LOW PASS SUBWOOFER OUTPUT TERMINALS To be connected to the subwoofer channel amplifier left/right inputs. [. . . ] FUSE This crossover uses a 1-amp, blade-type fuses for protection from power surges or a short circuit. POWER INPUT TERMINAL (12V) To be connected to the positive terminal of your vehicle battery or other constant +12V source. REMOTE TURN-ON INPUT TERMINAL (REMOTE) To be connected to the remote control wire or antenna lead of the source unit for remote ON/OFF. GROUND INPUT TERMINAL To be wired to the vehicle's chassis ground. To be connected to the remote control for exclusive maneuver of the subwoofer output level, and the subwoofer output level control on the unit ("16" below) is bypassed. LOW PASS SUBWOOFER OUTPUT GAIN CONTROL For adjusting the subwoofer channel output signal level. 3 ELECTRICAL & AUDIO CONNECTIONS 4 ELECTRICAL & AUDIO CONNECTIONS Precautions 1. To prevent short circuits, be sure to disconnect the negative battery ground lead before wiring the system up. When you finish the installation, be sure to make one more check to be sure everything is done correctly. [. . . ] Reconnect the negative battery ground lead. Primary Wiring Descriptions ELECTRICAL 12V PRIME CONNECTION BATTERY + DESCRIPTION Connect to the positive battery terminal (constant + 12V source) Connect to the vehicle's chassis ground (check for good ground) Connect to the remote control wire(or the electrical antenna) of the car radio/cassette deck Connect from pre-amp output of radio/tape player (or CD) into GROUND GROUND - REMOTE REMOTE B+(12V) INPUT RADIO/TAPE PLAYER TO CROSSOVER MODULE CROSSOVER MODULE TO ANY AMPLIFIER CROSSOVER MODULE TO SUB-WOOFER AMPLIFIER HIGH PASS OUTPUT LOW PASS OUTPUT Connect from "high-pass output" of CROSSOVER module to any amplifier input. [. . . ]