User manual PYLE PLVW65M

[. . . ] Then slide the position plate upward to the slot 2 and select the proper location. When mounting the monitor on the bracket, you can release the screw cover 1 to turn the rotation top upward or downward to find a good viewing angle, then rotate the screw cover 1 to fix the rotation top. The monitor can be rotated leftward or rightward by rotating the rotation base. [. . . ] You can connect earphone to any one of the jacks to receive sound signal. REMOTE Through the REMOTE jack (14), connect DVD unit or anther unit to the monitor. Then you can control the DVD unit or anther unit by pointing the remote control handset directly to the remote sensor IR (3). DIVERSITY ANTENNA There are four jacks (15) for diversity antenna input. This diversity antenna system allows four different TV RF signal input, and it can select one of the highest level of electrical filed strength automatically. DC 12V INPUT JACK Through this jack (16), provide DC 12V power supply to the unit. AV INPUT JACK The group of jacks (18) is used for VIDEO in, AUDIO R in and AUDIO L in. 6 TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. NO POWER Check if the power button on the front of the monitor is set to on. THE PICTURE IS OVER DARK, OVER BRIGHT OR HAS NO COLOR: Press MENU button on the front of the unit, then press VOLUME+ button or VOLUME- button to increase or decrease the level of the corresponding item (BRIGHT, CONTRAST, COLOR or TINT) to proper value, then you can get an optimum picture effect. Check if the volume is minimum, and press the VOLUME+ button to increase the volume level. CAN'T RECEIVE TV SIGNAL OR THE PICTURE QUALITY IS POOR IN TV MODE: Please confirm if the antenna is connected to the antenna socket of the unit. Perhaps the signal of your position is too weak, and it can't receive any TV signal at all. BUTTONS DO NOT WORK Turn the unit off and on with the power button on the front of the unit. 7 BRACKET 3 (BKT3) 8 INSTALLATION HARDWARE (2) (3) (4) (5) (1) (6) (7) (8) (9) (a) (10) (b) (1) ASSY (Rotate combined bracket with Base A. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 (2) Base B. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] INSTALL THE CAMERA Insert the position clip-screw(5) from underside into the hole on the tray and aim the screw of the position clip-screw (5)to the hole on the bottom of the camera, then rotate the position clip-screw (5) to fix the camera to the tray. (5)Position Clip-screw 12 ADJUST THE ANGLE OF THE TV UNIT OR THE CAMERA 1. To adjust the angle of the monitor Rotate the clip screw (6) to loosen the TV monitor, then rotate the TV monitor left or right to your need for good viewing angle and then rotate the clip screw tightly to fix the TV monitor. To adjust the angle of the camera Rotate the position clip-screw (5) to loosen the camera, then rotate the camera left or right to your need and then rotate the position clip-screw tightly to fix the camera. (6)Clip screw (5)Position Clip-screw 2. [. . . ]