User manual PYLE PLVH2

[. . . ] PLVH2 OWNER'S MANUAL INFRARED HEADPHONE INFRARED HEADPHONE This infrared headphone is supplied with the main unit that has the infrared transmitting function. [. . . ] Insert the battery by pressing the minus pole of the battery against the spring on the battery compartment until the plus pole can slide into the battery compartment. The battery should snap into place. Be sure to only use batteries with a well formed plus pole to ensure proper contact between the plus pole of the battery and the plus pole inside the battery compartment and also to ensure that the battery will not slide out of the battery compartment unintentionally. It should snap into the closed position. 2 Removing the headphone batteries: To remove the batteries, open the battery lid as described above and pull the battery out of the battery compartment by pushing the battery towards the spring until the plus pole is released and slides out. Never leave batteries inside the headphones for very long periods of time to prevent any damage to the headphones from leaking batteries. Check the remaining power of the headphone' s battery: When install two batteries into the battery compartments, switch on the headphone by slide the switch to "ON" position. Charge the battery or install a new dry battery, if the power indicator light is weak or turned off and the sound becomes distorted or has a lot of noise. 3 Listening to a program When the main unit is working, it will automatically transmit the audio signal, and then you can use the infrared headphone to listen to a program. Set the volume control of the headphone to minimum then switch on the headphone. The length of the headphone's band can be adjusted to your need. 2. [. . . ] Therefore, always set the volume control minimum. www. pyleaudio. com 4 88-00004-03 [. . . ]