User manual PYLE PLTVD7.5N

[. . . ] If the fuse(s) blow more than once, carefully check all electrical connections for short circuit, also have your vehicle's voltage regulator checked. DO NOT USE IMMEDIATELY IF A PROBLEM APPEARS When a problem appears, stop using the system immediately and contact the dealer from whom you purchased the equipment. 5 CAUTION DO NOT RAISE THE VOLUME EXCESSIVELY Keep the volume at a specific level which you can still hear outside noise while driving . Keeping the volume loud may cause an accident. DO NOT USE THIS EQUIPMENT OUTSIDE THE VEHICLE Do not use this equipment for purpose other than those listed for a vehicle. Failure to do so may result in an electric shock or an injury. HOW TO USE THE BATTERIES Do not mix new batteries with old batteries and do not replace with other than specified batteries. When inserting the batteries, be sure to observe proper polarity (+ and -) as instructed. [. . . ] SELECTING THE MENU You can select the menu to make this unit or AV sources connected to this unit operate in the best conditions. AV1, AV2, AV3 Mode : CONTROL->FUNCTION-> PICTURE->MENU OFF TV Mode : CONTROL->TUNING->FUNCTION->PICTURE->MENU OFF 2) Press SEARCH / button to select the item that you want to adjust. NOTE The MENU automatically disappears about 8 seconds after it appears on the screen. But if you want to erase it by manual, press MENU button repeatedly until the menu disappears. 13 FUNCTION 1. FM TRANSMITTER CONTROL This is to listen to the sound of AV sources connected to this unit with the car speakers. If you set the FM frequency of the FM transmitter in the following way and you have the FM Radio unit in your car, you can listen to the sound of AV sources of this unit. 1) Press MENU button to show FUNCTION menu on the screen. It will show the following menu. 2) Press SEARCH / button to select FM TRANS. ON : FM Transmitter on OFF : FM Transmitter off 4) Press SEARCH UP/DOWN button to select FM FREQ. 6) Tune the car radio's FM Radio to the same FM frequency of the FM Transmitter. NOTE The FM frequency range of the FM Transmitter is 89. 5 ~ 90. 2 MHz. 14 2. TILT POSITION CONTROL 1) Press MENU button to show FUNCTION on the screen. MOVE POSITION CONTROL 1) Press MENU button to show FUNCTION on the screen. NAVIGATION AUDIO ( In case, you use an optional compatible Navigation System) When a navigation system is connected to this unit, you can use the navigation system properly after you adjust the navigation audio control. If you press NAVI button on the remote control, the navigation mode will be displayed on the screen on any mode, when you connect the navigation system to this unit, you should connect it through RGB connector at the backside of this unit NOTE This is limited to only the unit with RGB connector. Press MENU button to select CONTROL menu, and press SEARCH / button to select NAVI AUDIO. OFF -> ON -> AUTO OFF ON : When a navigation system is not connected, the NAVI AUDIO should be set to OFF. : When a navigation system is connected to this unit through RGB connector, the NAVI AUDIO should be set to ON or AUTO. When the NAVI AUDIO is set to ON on the navigation mode, only the navigation audio is heard through the speakers. AUTO : When the NAVI AUDIO is set to AUTO on the navigation mode, the previous mode audio (TV) is heard through the speakers, when the navigation audio comes on, the previous mode audio is muted and the navigation audio is heard through the speakers. 16 2. SCREEN ASPECT CONTROL 1) Press MENU button to show CONTROL on the screen. CONTRAST CONTROL 1) Press MENU button to show PICTURE on the screen. 2) Press SEARCH / button to select CONTRAST. VOLUME : BRIGHT level will be increased and the screen will be brighter. [. . . ] If it is not working, consult installation shop where happens when microprocessor due to noise, etc. are has malfunctioned you purchased it from. 30 The headlight of The display is made dark at night to the vehicle is lit. prevent the glare (When the headlight of the vehicle is lit in the daytime, the display gets dark). The color of The color is not Check that Color and Tint are adjusted the light display is adjusted or a adequately. TV The image Bad receiving A radio wave may not reach sufficiently due to obstruction of mountains or buildings. [. . . ]