User manual PYLE PLR7N

[. . . ] MOTORIZED 7 IN -DASH LCD COLOR MONITOR WITH AM/FM STEREO RADIO MODEL: PLR7N OWNER S MANUAL Any changes or modifications in construction of this device which is not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. ! WARNING The exclamation point within an equilateral triangle and WARNING are intended to alert the user to the presence of important operating instructions. Failure to heed the instruction will result in severe injury or death. DO NOT WATCH VIDEO WHILE DRIVING Watching the video may distract the driver from looking ahead of the vehicle and cause an accident. DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. [. . . ] Press the VOLUME button to select the desired picture mode. 11 RADIO CONTROL Press the OPEN/CLOSE button to turn the power on and to open the monitor. Each time you press the MENU button on RADIO MAIN MENU screen, the menu on the screen changes as follows. RADIO SUB -> VOLUME -> USER SELECTOR -> PICTURE -> RADIO MAIN 2. You can select the items on each menu by pressing the SEARCH UP/DOWN button. You can adjust the level of the selected items by pressing the VOLUME or CH UP /DOWN button. MANUAL TUNING Press the CH UP/DOWN button to move downward or upward one step respectively until the desired station frequency is selected. MANUAL STORING OF STATION 1. The station will be stored into the next CH number of the last CH number previously stored station. FM1:30, FM2: 30, AM1:30, AM2:30 stations (total 120 stations). 12 AUTO MEMORY OF STATION 1. The frequency on the display continues to change while the auto memory is in progress. The tuner will automatically seek and can store up to 30 stations in each band in order of frequency signal. They can be stored in FM1: 30, FM2: 30, AM1: 30 and AM2: 30 stations (total 120 stations). When the auto memory has been completed, the tuner goes to the station stored in the CH No. 1. NOTE On CD changer mode, you can pause or playback the current CD by pressing the AS/ATM button. TUNING TO THE STORED STATION Press the SEARCH UP/DOWN button repeatedly until the desired station is selected. SELECTING THE BAND AREA FOR YOUR COUNTRY 1. When RADIO BAND is selected, press CH UP/DOWN button to select the radio band area (EUROPE or USA) for your country. Each time you press the CH UP/DOWN button, the band switches as EUROPE --> USA 13 RADIO BAND 1. When RADIO BAND is selected, press the VOLUME button to select the band. The monitor shows the back view camera picture. WIRING CONNECTION Connect orange color connection wire named "REVERSE GEAR" to a switched power output terminal of the R (reverse) gear. See page 26: BASIC CONNECTIONS. NOTE If AV input connected to the Back view Camera is selected with the MODE button, the monitor does not show the back view camera picture. The Monitor shows only the WARNING picture. 16 CD CHANGER CONTROL When a CD (VCD) changer is connected to this unit with 8 pin DIN cable, AV3 mode changes to CDC mode and CDC control menu is displayed on the screen. When CD CHANGER (AV3) mode is selected, The monitor shows following picture. 3. You can also adjust the level upward by pushing the BAND button on the unit. NOTE 1. Each time the MENU button is pressed on CDC mode, the menu on the screen changes as follows. CD CHANGER -> VOLUME -> USER SELECTOR -> PICTURE -> OSD OFF 2. The CD (VCD) changer must be connected to the 8pin DIN socket on the rear of the unit with the 8pin DIN cable in our CD/VCD changer gift box. [. . . ] Press the MENU button when the monitor shows following picture. USER SELECTOR MENU USER SELECTOR TILT POSITON MOVE 0 FORWARD The monitor shows following picture. PICTURE MENU 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. Press the VOLUME button to adjust the level of the selected item. 22 SELECTING COLOR/SOUND SYSTEM 1. Press the SEARCH UP/DOWN button to select COLOR SYSTEM for the video source on PICTURE menu. PICTURE MENU 2. [. . . ]