User manual PYLE PLPK5TVD

[. . . ] For details, refer to the following illustrated installation methods. DIN FRONT-MOUNT Installing the unit 1 2 182 1. Holder After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. Strap Be sure to use the strap to secure the back of the unit in place. [. . . ] - Set minutes: Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press button (13) to adjust the minutes. · LIQUID CRYSTAL DISPLAY The LCD (4) can show the current state of the unit. · RESET Reset button (24) must be activated with either a ball-point pen or thin metal object. The reset button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - Error symbol on the display. 10 RADIO OPERATION · SELECTING BAND Press BAND button (11) to change between three FM bands and two AM bands. Each band stores up to six preset stations. FM1 FM2 FM3 AM1 AM2 · SELECTING STATION During radio mode, press MAN/SKP button (13) to increase frequency or (14) to decrease frequency by one step of channel spacing. · SELECTING MEMORY Press preset memory buttons (15) to preset stations at tuner mode. With this system, a total of 30 stations can be stored in the memory of six buttons. The operation is as below: - Store in Memory Press and hold desired memory location button for several seconds. - Retrieve a Preset Station Press any one of the buttons (15) to retrieve a station which had been stored in the memory in advance the chosen number is shown on display. · AUTO MEMORY STORING & SCANNING - Auto Memory Scanning Check the stations stored in the preset memories. Press to retrieve automatically the current stations stored in six preset memories and it will display for several seconds. Press either the AS/PS button (16) again or anyone of the memory buttons to stop the scan operation. During the preset scan operation, the channel number flashes on the display for several seconds. - Auto Memory Storing Seeks the six strongest stations in the pre-selected band automatically and stores the stations automatically in preset memories. Initially the tuner seeks and memories the stations in local mode until 6 stations are fully occupied. [. . . ] POWER TV/AV 0-9 -/-MUTE = = = = = Press POWER to turn the unit ON or OFF Switch between TV/AV1/AV2 Numeric buttons, press to select the corresponding channel Digital selecting button, cooperatively used with numeric buttons Press to mute the sound. When release the button, the screen will display VOLUME XX for about 4 seconds, and this is the AUDIO level setting value of the TV unit. The users may not mind it, and that adjust the volume level by VOL + and VOL ­ buttons. [. . . ]