User manual PYLE PLDCP6 INSTALL GUIDE

[. . . ] Model: PLDCP6 6F Hybrid Super Cap (carbon and electronic capacitor) With Blue Digital DC Voltage and Amperage Display, Blue LEDS In Front INSTALLATION AND MOUNTING: You must first attach the mounting tabs to the capacitor before mounting it. [. . . ] If the capacitor is connected incorrectly by reversing the positive and negative wires during the installation process the PCB will issue a 45 second noise to warn you. d) Hi-end platinum plated 100% brass solid parts and chrome plated metal cover e) Blue flash LED line on the front side of HYBRID SUPER CAPACITOR. g) Multiple small capacitance capacitors linked to provide the lowest inner E. S. R. a) CHARGING THE CAPACITOR AND WIRING: The capacitor must be charged before connecting the Power and Ground cables to the capacitor. Failure to charge the capacitor will result in a large spark generated from the rapid inflow of current. 1 2 To Charge the capacitor: 1. Make Capacitor positive terminal connections with amplifier and tighten the bolt. Caution: Stripped terminals are not covered under the capacitor's warranty. Connect the ground cable with battery, amplifier, then refer to the attached drawing. [. . . ] PLEASE REFER TO THE INSTRUCTIONS CONTAINED IN THIS MANUAL FOR CORRECT MOUNTING, CHARGING/DISCHARGING AND WIRING CONNECTION FOR THIS CAPAPCITOR PRIOR TO INSTALLATION. To Discharge the capacitor: With battery power disconnected, place the light bulb or resistor across the capacitor's positive and negative terminals until light goes out or for three minutes if using a resistor. 3 4 [. . . ]