User manual PYLE PLCM7000

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PYLE PLCM7000. We hope that this PYLE PLCM7000 user guide will be useful to you.


PYLE PLCM7000 : Download the complete user guide (83 Ko)

Manual abstract: user guide PYLE PLCM7000

Detailed instructions for use are in the User's Guide.

[. . . ] Insert fingers into the groove in the right side of the frame and pull out to remove the frame. Lever After removing the frame, press the OPEN/CLOSE button again to slide up the front panel. Then insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. [. . . ] Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 x 5mm), depending on the shape of the screw holes in the bracket. Dashboard or Console Note: The mounting box, outer trim ring, and half-sleeve are not used for method B installation. 4 USING THE DETACHABLE FRONT PANEL To Detach the Front Panel 1. Press the OPEN/CLOSE button, the front panel will slide down. To Reinstall the Front Panel 1. When the panel bracket is in slide down position, insert the front panel into panel bracket and press OPEN/CLOSE button to slide up. Open/Close 2. Press the OPEN/CLOSE button again, the front panel will slide up. Bottom Button 2. When the panel bracket is in slide up position, insert a side of the front panel to its proper position and push the other side into the panel bracket, a `click' sound should be heard. Open/Close Front Panel 3. When the front panel slides down, press the bottom button of the front panel upward and pull it out from the panel bracket. Note that if the front panel fails to lock in position properly, press control button may not function and LCD display may be missing some segments. Press the OPEN/CLOSE button and then reinstall the front panel again. Bottom Button 4. For safekeeping, store the front panel in the supplied protective case immediately after being removed. Protective Case Front Panel 5 WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR (BLACK) CD IN IGNITION RED SWITCH (B+) MEMORY YELLOW BACK-UP BLACK GROUND (B­) POWER ANTENNA Rch RED Lch WHITE (GREY) CHOKE BOX BLUE RCA CABLE Rch RED Lch WHITE FRONT Lch SPEAKER WHITE WHITE/BLACK GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK FRONT Rch SPEAKER REAR Lch SPEAKER REAR Rch SPEAKER 6 OPERATION 10 11 24 8 2 23 15 1 7 4 13 16 12 17 19 20 21 14 22 5 18 6 9 3 GENERAL OPERATION · ON/OFF Switch on the unit by pressing any button (except OPEN/CLOSE button (7) and EJECT button (4)). · AUTOMATICALLY MEMORY STORING & PROGRAM SCANNING - Automatic Memory Storing Press AMS button (18) for several seconds, the radio searches from the current frequency and checks the signal strength until one cycle search is finished. And then 6 strongest stations are stored into the corresponding preset number button. - Program Scanning Press AMS button (18) shortly to scan preset station. When the field strength level is more than the threshold level of stop level, the radio is holding at that preset number for several seconds with releasing mute, then searches again. · STATION STORING Press any one of the preset buttons (14) (M1 to M6) to select a station which had been stored in the memory. Press this button for several seconds, current station is stored into the number button. CD OPERATION · SELECT TRACKS Press TUNE/SKIP/TRACK button (16) or TUNE/SKIP/TRACK button (17) to move to the previous track or the following track. Hold TUNE/SKIP/TRACK button (16) or TUNE/SKIP/TRACK button (17) to fast reverse or fast forward. · REPEAT THE SAME TRACK Press RPT button (21) to continuously repeat the same track. · PREVIEW ALL TRACKS Press SCN button (20) to play first several seconds of each track on the current disc. · PLAY ALL TRACKS DPress SHF button (22) to play all tracks on CD in random order. · EJECT When the front panel is sliding down, press EJECT button (4) to stop CD playing and eject the disc from the disc slot (5). [. . . ] · EJECT When the front panel is sliding down, press EJECT button (4) to stop CD playing and eject the disc from the disc slot (5). NOTE ON CD-R/CD-RW DISCS · On this unit, in addition to an audio CD, you can play your original CD-R or CD-RW that contain audio titles. · However, depending on the conditions of the recording equipment or the CD-R/ CD-RW disc itself, some CD-Rs or CD-RWs cannot be played on this unit. onto the label side or the recording side of any CD-R/CD-RW, as it may cause a malfunction. 9 REMOTE CONTROL HANDSET 1 7 4 3 8 6 13 12 11 15 9 5 2 10 14 FUNCTION KEYS & CONTROL 1. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PYLE PLCM7000




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PYLE PLCM7000 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.