User manual PYLE PLCDCS90 Instruction Manual

[. . . ] 1- bit Pickup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Optical 3-beam semiconductor laser Output filter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Active Frequency response. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Hz - 20KHz Dynamic range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85dB Signal-to-noise ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90dB Wow and flutter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Below measurable limits Channel separation(1 KHz). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85dB CD TA PWR + BD FF TUNE SEEK TRACK FULL LOGIC CASSETTE/RECEIVER/CD-R/W PLAYBACK HIGH POWER 35WX4 AUDIO CONTROL + LOC WF CLASS FLAT ROCK POP LUD DISC RDM RPT INT MUT MTL CH SEL -- REW PAUSE MTL CD - CH LUD DISC + -- 1RDM 2RPT 3 SCN CD TA WOOFER 4 5 6AMS 19 18 17 16 15 14 13 12 11 10 20 1. BAND BUTTON Press it to switch from tape, CD player or CD changer mode to radio, and the LCD screen will be shown as below: FM 1 FM 2 FM 3 MW(AM) 1 MW(AM) 2 2. 19. [. . . ] Then if you press FF or REW button, it allows you to skip forward or backward to the beginning of a particular selection. The microcomputer has been affected by electrical noise. The radio does The signals are weak. not stop on any stations when automatic tuning is used. In CD changer mode, press the DISC + button to select the next disc and the DISC - button to select the preceding disc. INSTALLATION 13. LOUD/SUB WOOFER Press it shortly to enhance the bass effect during bass mode. then press SEL button to select the sound mode such as volume, bass, treble, balance and fader, and then press + or - button to increase or decrease the volume level of the selected sound mode. 14. TAPE BUTTON Press it to switch from radio, CD player or CD changer mode to tape mode. In tape mode, press it to make the player automatically switch to the opposite side of the tape when the tape reaches the end of one side. 15. CD/CD-CH BUTTON Press it to switch from radio or tape mode to CD player or CD changer mode. When a disc is loaded in the disc compartment and the CD changer is not connected, the mode changes like this: Radio/Tape CD player CD player pause 2). When a disc is not loaded in the CD player and the CD changer is connected, the mode changes like this: Radio/Tape CD changer CD changer pause 3). When a disc is loaded in the CD player and the CD changer is connected, the mode changes like this: Radio/Tape CD player CD changer KEY PLATE KEY PLATE PLASTIC TRIM OUT DASH BOARD METAL MOUNTING STRAP HEX NUT SPRING WASHER PLAIN WASHER PLAIN WASHER TAPPING SCREW CONSOLE SLIDE BRACKET HOUSING HEX BOLT 16. SCAN BUTTON In CD player mode, press it to search each song for 10 seconds, press it again to stop scanning and retain the song currently selected. In CD changer mode, press it to search each song for 10 seconds, press it again to search each disc for 10 seconds, press it thirdly to stop scanning and retain the disc currently selected. If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, remove the PLASTIC OUTLINE away, then insert the two KEY PLATE into left and right side of chassis as above illustration. PRECAUTIONS AND MAINTENANCE . 1. This unit is designed for negative ground operation only. [. . . ] In CD changer mode, press it to play tracks on the current disc in random order. In tape mode, press it to pause tape playing, press it again to resume tape playing. [. . . ]