User manual PYLE PLCD82MP Instruction Manual

[. . . ] Taking a minute to do this now will help to prevent hearing damage or loss in the future. ABOUT THIS MANUAL This product features a number of sophisticated functions ensuring superior reception and , operation. All are designed for the easiest possible use, but many are not self-expanatory. This operation manual is intended to help you benefit fully from their potential and to maximize your listening enjoyment. [. . . ] Chassis dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 178[W] X 50[H] X 165[D]. \ \ . Do not stick paper or tape on the disc. . Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Or leave it in a car parked in direct sunlight where there can be a considerable rise in temperature. 9 2 INSTALLATION INSTALLATION WAY IT IS AN ANTI-THEFT INSTALLATION WA THE CHASSIS WEAR A MET Y. PLEASE HAVE THE WIRING CONNECTION OF THE POWER SUPPLY SPEAKERS AND ANTENNA AS FOR THE REQUIREMENT , OF THE MANUAL, THEN INSTALL THE METAL SLIDING HOUSING INTO THE CAR ACCORDING TO THE DIAGRAM. TO BOOST UP THE CAPABILITY OF ANTI-JAMMING, PLEASE FIX THE METAL STRAP ON THE METAL CONNECTED TO THE BOTTOM BRACKET OF THE CAR. REMOTE CONTROL BASICS BATTERY REPLACEMENT: 1. Remove the battery holder as the direction indicated by the arrow. Push in the holder to the original position. NOTE ON BATTERIES: Old batteries must immediately be removed and disposed. BATTERY INFORMATION: SELECT THE PROPER FIXER FOR FIXING THE SLIDING METAL HOUSING. METAL STRAP Designated Battery: UM-4"AAA"/R05 Battery Life: 6 months with normal use (in normal room temperatur) CAUTION: UNIT CHASSIS PLASTIC TRIM OUT DASH BOARD SLIDING METAL HOUSING Improper use of batteries may cause overheating, explosion or ignition. Resulting in jury or fire . Battery leakage may cause damage to the unit. To avoid the risk of accident, keep the batteries out of reach of children. FRONT PANEL TO DRAW THE CHASSIS OUT OF THE SLIDING METAL HOUSING, INSERT THE LEFT AND RIGHT KEY PLATES INTO THE RIGHT POSITION OF THE 2 SIDES OF CHASSIS. TO INSTALL THE FRONT PANEL BACK INTO THE UNIT CHASSIS, FIRSTLY INSTALL THE RIGHT SIDE IF IT BACK INTO THE RIGHT POSITION, THEN PUSH THE LEFT SIDE BACK TO THE UNIT CHASSIS TILL OK. NOTE REMOVE AWAY 2 SCREWS FOR PROTECT THE DECK BEFORE OPERA TING IT. REMOVE THE SLIDING METAL HOUSING AWA Y PRESS RESET BUTTON TO RESUME THE DISTORTED PROGRAM WHEN THE LCD DISPLAY IMPROPERLY AND SOME BUTTONS ARE INVALID. RESET BUTTON 1. LOCAL/DISTANCE BUTTON If you find the receiving signal is weak and there is the word LOC displayed on LCD when you tune for distance station, firstly press the button to disappear the word LOC on LCD, then tune again for the distance station. If you find the interference to the receiving signal is very strong and there is not the word LOC displayed on LCD when you tune for local station, firstly press the button to display the word LOC on LCD, then tune again for the local station. AFTER FLIPPING DOWN THE FRONT PANEL, DRAW THE FRONT PANEL OUT OF THE CLIP. 2. LOUDNESS BUTTON Press it to enhance the BASS sound effect immediately when it is in BASE mode. OPEN BUTTON TO INSERT DISC INTO COMPARTMENT OR EJECT DISC OUT OF THE COMPARTMENT OR TAKE THE FRONT PANEL AWAY THE UNIT CHASSIS, PRESS THE OPEN BUTTON TO FLIP DOWN THE FRONT PANEL. 3 8 LOCATION AND FUNCTION OF CONTROLS 12. (A]. To memorize the current frequency, press any one of the six preset buttons hold for more than 2 seconds. (B]. To recall the preset memory, press one of the preset buttons [1-6]. (C). In CDP mode, press TOP/CDP button to pause CDP playback, press it again to resume CDP playback. Press it hold for more than about 0. 5 seconds to play the first track of the disc. (D). In CDP mode, press INT button to play the first 10 seconds part of each track, press it again to stop INT mode and retain playing the track currently selected. (E). In CDP mode, press RPT button to play the current track repeatedly. (G). In MP3 mode, M5 and M6 is assigned as 10 TRACK up/down when normal play. V-SEL/MENU/ENTER(SEL) AND V-UP/DN, MENU-UP/DN(+/-) BUTTONS (1). Press SEL button shortly and repeatedly to select sound mode VOLUME, BASS(without preset DSP), TREBLE(without preset DSP), BALANCE and FADER, then press + or - button to adjust level of the selected sound mode. (2). Press SEL button hold for more than 1 second to turn on MENU mode, and the LCD will display DSP OFF/POP M/ROCK M/CLASS M/FLAT M, then press SEL button shortly and repeatedly to select ESP12/ESP45, BEEP ON/BEEP OFF, SEEK1/SEEK2, VOL LAST/VOL ADJ(When it is in VOL ADJUST mode, the next mode will be A-VOL after VOL ADJUST mode, then you can adjust the volume level) in the sequence and circulation. [. . . ] During the memory station performing, press 1-6 digital buttons to select and stop scanning function. (2)In MP3 mode, press A. P button repeatedly to select TRACK SEARCH, FILE SEARCH or CHARACTER SEARCH mode. BAND BUTTON Press it repeatedly to select your desired radio band during RADIO mode. CLOCK BUTTON Press CLK button to display time on LCD, then press CLK button hold until time flashes on LCD, thirdly press + or - button to adjust HOUR or MINUTE. [. . . ]