User manual PYLE PLCD69MP3

[. . . ] For details, refer to the following illustrated installation methods. 3 (Fig. 6. Dashboard Nut (5mm) Spring washer Screw (5 x 25mm) Screw Strap Be sure to use the strap to secure the back of the unit in place. Plain washer INSTALLATION Removing the unit 1 2 3 Factory-installed radio bracket Car radio mounting bracket Screw After aligning the car radio mounting bracket with the factory-installed radio bracket, tighten the screws (M5x4mm) at 2 places on each side. [. . . ] Note: If press RESET button (25), the unit can't work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the front panel. · AUXILIARY INPUT The unit can be connected to a portable audio player through the AUX IN jack (7). · REMOTE SENSOR Point the remote control handset to the remote sensor IR (26). Press the function keys on the handset to control the system. 8 OPERATION RADIO OPERATION · BAND SELECTION At tuner mode, press LOU/BND button (13) shortly to select the desired band. The reception band will change in the following order: FM1 FM2 FM3 AM · AUTOMATICALLY MEMORY STORING & PROGRAM SCANNING - Automatic Memory Storing Press AMS button (18) for several seconds, the radio searches from the current frequency and checks the signal strength level until one cycle search is finished. And then 6 strongest stations are stored into the corresponding preset number button. - Program Scanning Press AMS button (18) shortly to scan the preset station. When the field strength level is more than the threshold level of stop level, the radio is holding at that preset number for several seconds with releasing mute, then searches again. · STATION STORING Press any one of the preset buttons (14) (M1 to M6) to select a station which had been stored in the memory. Press this button for several seconds, current station is stored into the number button. · STATION SELECTION Press MANU/SKIP button (16) or MANU/SKIP button (17) shortly to activate automatic seek function. Press for several seconds until "MANUAL" appeared on the display, the manual tuning mode is selected. If both buttons have not pressed for several seconds, they will return to seek tuning mode and "AUTO" appeared on the display. · LOCAL/DISTANCE Press LOC button (3) to select between local and distant stations. Local setting for reception of strong station, and a distant setting for reception of weaker stations. · MONO/STEREO Press MON button (1) to select mono or stereo mode. You can sometimes improve reception of distant stations by selecting mono operation. · SCAN Press SCN button (24) to set function to scan mode, which scanning to higher frequency station with receivable signal and keep on each station for several seconds. 9 OPERATION CD OPERATION · CD OPEN/CLOSE/EJECT When the front panel is in State 2 and the unit is on, press (eject) button (4), the panel will change into State 3 and display the disc slot (5). Then insert a disc into the slot, the panel will automatically turn up. And after about 10 seconds, the panel will turn up. · SELECT TRACKS Press MANU/SKIP button (16) or MANU/SKIP button (17) to move to the previous track or the following track. [. . . ] If any of the problems persist after check list has been made, consult your nearest service dealer. Solution If the power supply is properly connected to the car accessory circuits, but the engine is not moving, switch the ignition key to "ACC". Disc cannot be loaded or ejected. Presence of CD disc inside Remove the disc in the player, then the player. [. . . ]