User manual PYLE PLCD15MR

[. . . ] Screw 3 INSTALLATION Removing the unit 1 6 2 3 7 4 5 1 Front Panel OPEN button (Fig. 6. Dashboard Nut (5mm) Spring washer Screw (5x25mm) Screw Strap Be sure to use the strap to secure the back of the unit in place. Before removing the unit, press the OPEN button to slide down the front panel. [. . . ] Then press the button (17) to change minutes or button (16) to change hours. · DISPLAY PRIORITY Clock Priority Press and hold DISP button (1) while pressing button (16) to select Clock Priority. Pressing DISP button (1) while in Clock Priority will temporarily display selected station frequency (in RADIO mode) or track number (in CD/CDC mode) or state information (in AUX IN mode). Frequency Priority Press and hold DISP button (1) while 8 pressing button (17) to select Frequency Priority. Pressing DISP button (1) while in Frequency Priority will temporarily display clock. · SELECTABLE CLOCK DISPLAY Programs the unit to display the clock (selectable on/off) when the unit is turned off. While the unit is turned on, pressing and holding MODE button (6) and then pressing M2 button (20) toggles the selectable clock display. · LIQUID CRYSTAL DISPLAY Exhibit current frequency and activated functions on the display (8). · RESET Reset button (25) must be activated with either a ballpoint pen or thin metal object. The reset button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. Note: If press reset button (25), the unit can't work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the front panel. OPERATION RADIO OPERATION · BAND SELECTION At tuner mode, press BAND button (18) shortly to select the desired band. The reception band will change in the following order: FM1 FM2 FM3 AM2/MW2 AM1/MW1 · STATION STORING Press any one of the preset buttons (14) (M1 to M6) (i. e. 19~24) to select a station which had been stored in the memory. Press this button for several seconds, current station is stored into the number button. · SCAN Press SCAN button (13) to scan through strong stations in the current band. · SELECTABLE FREQUENCY SPACING (FOR USA VERSION ONLY) Programs the unit for USA or European radio frequency spacing. While in radio mode, pressing and holding BAND button (18) and then pressing button (17) or button (16) toggles between USA or European frequency spacing. - Pressing and holding BAND button (18) and then pressing button (17) selects USA frequency spacing. - Pressing and holding BAND button (18) and then pressing button (16) selects European frequency spacing. [. . . ] (Please refer to the manual of your CD-R/CD-RW recorder or CD-R/CD-RW software for more information on finalization process). Depending on the recording status, conditions of the disc and the equipment used for the recording, some CD-Rs/CD-RWs may not be played on this unit. (see *1) *1:To have more reliable play back, please see following recommendations: a: Use CD-RWs with speed 1x to 4x and write with speed 1x to 2x. [. . . ]