User manual PYLE PLCD10CH

[. . . ] · Up to ten discs can be loaded. Label side up Play side down Installing the magazine 1. First check that the magazine with the discs has its top side facing up and it is pointed in the right-direction for installation. [. . . ] · When installing the unit, do not use any screws that are part of the brake or steering system. This unit cannot be installed in any way except that which is authorized (on its side, on its end, at a 45° angle or suspended). Installing it with its side facing down upside down can cause malfunctioning. 6 Position of the built-in anti-vibration board This unit can be installed horizontally (suspended), vertically, and at a 45° angle. Once the installation position has been decided, it's necessary to set the position of the built-in anti-vibration board inside the unit. Vibration may cause the disc to skip if the unit is used before properly setting the anti-vibration board. · At the time of shipping, the built-in anti-vibration board is set for horizontal installation "0". · There are built-in anti-vibration boards on both the left and right sides. · Set the anti-vibration board position with a screwdriver before attaching the brackets. For use when unit is installed horizontally or suspended: Confirm that the built-in anti-vibration board is set to position "0". 0 For use when unit is installed vertically: The built-in anti-vibration board should be set to position "90". 90 90 4 5 45 0 For use when unit is installed at a 45° angle: The built-in anti-vibration board should be set to position "45°". 90 45 0 45° 7 INSTALLATION Procedure for Installation on Carpet (Horizontal Position) 1 · Confirm that the built-in anti-vibration boards on both the left and right sides are set to the horizontal installation position "0". · Attach the left and right brackets (A) using the hexagonal bolt (M4 x 5). · Attach the left and right brackets (A) to their respective brackets (B) using the hexagonal bolts (M6 x 12) and the hexagonal nuts (M6). Built-in anti-vibration board position Hexagon bolts (M6 x 12) Hexagonal bolts (M4 x 5) 2 · Pull back the carpet and determine where to attach the unit. · Stick the supplied double-sided tape to the bottom of the brackets (B) and peel off the paper backing. · Affix the unit to the floor by pressing in place. 3 · Remove the hexagonal nuts and take off the changer. 4 · Using a knife, cut "X"s in the carpet directly above the brackets (B) bolts. · Return the carpet to its original position allowing the bolts to stick through. 5 · Once more, use the hexagonal nuts to attach the changer on top of the carpet. 8 INSTALLATION Procedure for Installation on Carpet (Vertical Position) 1 · Set that the built-in anti-vibration boards on both the left and right sides are set to the vertical installation position "90". [. . . ] Such chemicals would irreparably damage the disc's plastic surface. Discs should be put back in their cases after to avoid serious scratches that could cause sound skip. [. . . ]