User manual PYLE PDWM96
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PYLE PDWM96. We hope that this PYLE PDWM96 user guide will be useful to you.
Manual abstract: user guide PYLE PDWM96
Detailed instructions for use are in the User's Guide.
[. . . ] Handle the wireless system carefully, dropping or other shocks may cause failure. Avoid using the system where it may be subjected to heat, such as direct sunlight, near radiators or other heat sources. It may be possible to dry the system, but you should have it checked by a qualified technician
Precautions Products figure Hand-held microphone Bodypack transmitter Receiver Front panel Receiver Rear Panel Installation Trouble shooting Specifications
before using it again. [. . . ] It may be possible to dry the system, but you should have it checked by a qualified technician
Precautions Products figure Hand-held microphone Bodypack transmitter Receiver Front panel Receiver Rear Panel Installation Trouble shooting Specifications
before using it again. If damaged in any way, do not use the system and refer to a qualified technician for repair. If the wireless system is not going to be used for a while, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove the leakage with a damp cloth. Take care not to get battery electrolyte in contact with your skin, however if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately. Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation. Do not use any solvents to clean any part of the wireless system .
A. Overall system Oscillation mode: Carrier Frequency Range: Stability: Max Deviation: Dynamic Range: S/N Ratio: T. H. D: Squelch: Frequency Response: Operating range: B. Before operation, please confirm that the frequency of transmitter is same as the frequency of receiver. Plug the 3. 5mm connector of headset mic to screw-lock socket of transmitter. The MUTE switch cuts off the audio output without shutting off the transmitter. If the system will not be used for a long time, please switch off the transmitter to avoid power consumption.
7
FRONT PANEL
3 1 4 5 6 7 8 9 10 11
REAR PANEL
3
DC IN 15V/500mA
PDWM96 VHF PROFESSIONAL FOUR CHANNELS WIRELESS MICROPHONE SYSTEM
VOLUME
RF
AF LEVEL
VOLUME
RF
AF LEVEL
VOLUME
RF
AF LEVEL
VOLUME
RF
AF LEVEL
XLR MIXED
MIXED
CH-1
SQ4
SQ3
SQ2
SQ1
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
17 16
18
19
POWER
20
21
16
2
12
13 7. CH-2 RF Signal Indicator
17. Balanced output jack 18. Unbalanced output jack 19. CH-1 Output jack 20. Squelch adjustor 21. DC Power in
Attach the two antennas and extend them vertically. The red indicator RF/Channel1, RF/Channel2, RF/Channel3, RF/Channel4 will come on to indicate signal reception. The green AF LEVEL meters indicate the audio level.
Adjust the volume of receiver, transmitters and amplifier. Please switch off the receiver, transmitters and amplifier when the wireless microphone system is not being used.
SQUELCH The squelch control on the rear of the receiver is preset at the factory. [. . . ] The red indicator RF/Channel1, RF/Channel2, RF/Channel3, RF/Channel4 will come on to indicate signal reception. The green AF LEVEL meters indicate the audio level.
Adjust the volume of receiver, transmitters and amplifier. Please switch off the receiver, transmitters and amplifier when the wireless microphone system is not being used.
SQUELCH The squelch control on the rear of the receiver is preset at the factory. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PYLE PDWM96
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PYLE PDWM96 will begin.