User manual PYLE PDWM4300 OPERATION MANUAL
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PYLE PDWM4300. We hope that this PYLE PDWM4300 user guide will be useful to you.
Manual abstract: user guide PYLE PDWM4300OPERATION MANUAL
Detailed instructions for use are in the User's Guide.
[. . . ] PDWM4300
VHF WIRELESS SYSTEM
PDWM4300
VHF WIRELESS SYSTEM
OPERATION MANUAL
OPERATION MANUAL
VHF WIRELESS SYSTEM OPERATION MANUAL
Thank you for buying the PDWM4300 Wireless System. Please read through these operation instructions so you will know how to operate your model properly. [. . . ] Transmitter Mike capsule: Antenna: RF Output: Spurious: Battery:
Quartz controlled VHF 169-270MHz 0. 005% 56KHz with level limiting 100dB 80dB 0. 5% "Pilotone & Noise lock" dual squelch circuit 100Hz~15KHz Up to 240 Feet
PDWM4300 PDWM4300
6dB V at S/N>90dB >60dB >80dB -12db/600ohms unbalanced and balanced 15VDC/0. 5A 16. 5 8. 2 1. 8 inch
POWER
PDWM4300 VHF PROFESSIONAL FOUR CHANNELS WIRELESS MICROPHONE SYSTEM
VOLUME
RF
AF LEVEL
VOLUME
RF
AF LEVEL
VOLUME
RF
AF LEVEL
VOLUME
RF
AF LEVEL
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
Dynamic microphone(Handheld mic) Condenser Microphone(Headset mic/clip-on mic) Built-in housing(Handheld transmitter) External(Belt pack transmitter) <10mW <-40dB one 9V battery
9
The on air indicator does not light up
The wireless microphone is not turned on. The AUDIO OUT on the receiver is not set correctly.
Turn on the wireless microphone Turn on the microphone receiver and the connected audio equipment Turn on the microphone receiver and the connected audio equipment Replace the battery. Connect the speakers/ headphones Replace the battery.
No sound
The sound is distorted
Adjust the volume controls.
Move the wireless microphone away from the speakers or change the direction of the microphone. Unscrew the battery cover at the end of microphone, put a 9V battery into compartment with correct polarities, then close the cover. Move "ON/OFF" switch to "ON" position, "PWR" indic ator will light for one s econd and then go off. If it doesn't come on, please check the voltage of battery or polarities. If the "PWR" indicator lights red, this indicates the battery power is low. Please replace with a fresh battery.
The distance between the wireless microphone and speakers are too A howling noise close. The battery in the wireless microphone is weak
8
Using the supplied audio cable, connect from the MIXED jack socket to the "MIC IN" / "LINE IN" socket on amplifier. Alternatively, you can connect an optional XLR cable from the "XLR MIXED" socket on the receiver to a professional mixer. Connect the mains power adaptor from "DC 15V" jack to a suitable mains power socket. away from wall
BELT CLIP BATTERY COVER AUDIO OUTPUT JACK VOLUME SWITCH AUDIO SWITCH POWER SWITCH
LOW BAT ON MUTE
-20dB 0dB OFF ON
MIC/LINE
AUDIO POWER ATTENUATION POWER
MIC LINE
MIC LINE
MIC LINE
MIC LINE
MIC LINE
9V +
ANTENNA HEADSET MIC
LOW BATTERY LED POWER LED
LAVALIER MIC
DC IN 15V/500mA
XLR MIXED
MIXED
CH-1
SQ4
SQ3
SQ2
SQ1
Open the battery cover to install a 9V battery (check polarities). [. . . ] This adjustment can
cause reduction in useable range of the wireless transmitter, so set the control to the lowest position that reliablely mutes the unwanted RF signals. Note that switching the microphone on and off can cause interference that will be heard if the microphone volume level of the amplifier system is still set high.
6 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PYLE PDWM4300
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PYLE PDWM4300 will begin.