User manual PYLE PDWM2600
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PYLE PDWM2600. We hope that this PYLE PDWM2600 user guide will be useful to you.
Manual abstract: user guide PYLE PDWM2600
Detailed instructions for use are in the User's Guide.
[. . . ] PDWM-2600
www. pyleaudio. com
PDWM-2600
DUAL UHF WIRELESS MICROPH0NE SYSTEM OPERATION MANUAL
Thanks for your support and trust to us while choosing our wireless microphone series with excellent quality. To ensure it functions well, Please read this manual carefully before operation. [. . . ] Do not use any solvents to clean any part of the wireless microphone system .
RECEIVER UNIT/operation
PDWM-2600
DUAL UHF WIRELESS MICROPH0NE SYSTEM
ANT
MIX
SQUELCH
DC 12V
ANT
PDWM-2600
BALANCED
AF. A
OPERATION
Switch on the wireless microphone receiver unit by pressing the POWER switch and the POWER light will illuminate to show the receiver unit is working. The positioning of the aerials is not critical for performance; ideally it should be fully extended. Switch ON the microphone, checking that the red LED comes on for a second and then goes off. When the microphone is ON, the SIGNAL light will illuminate on the receiver unit. The wireless microphone is now ready for use; adjust the volume and tone levels of your amplifier system as well as the receiver & the handheld mic as required. When the wireless microphone is not being used, turn OFF the microphone. Note that switching the microphone on and off can cause interference that will be heard if the microphone volume level of the amplifier system is still set high.
PDWM-2600
DUAL UHF WIRELESS MICROPH0NE SYSTEM
---1---
---2---
HANDHELD MICROPHONE/DIAGRAM
UNSCREW BATTERY COVER TO INSERT BATTERY
INSTALLATION
To connect the wireless microphone to your amplifier system: Refer to the installation diagram below. Using the supplied jack-to-jack lead, connect from the AF OUT jack socket to the MICROPHONE INPUT socket on your amplifier. Plug the mains power adapter into a suitable mains socket, and plug the lead connector into the DC 12V input socket. [. . . ] Check the settings of the microphone controls on the amplifier, adjust volume and tone to get the best sound without any trace of feedback.
SPECIFICATIONS
A. Battery: Quartz controlled UHF690-960MHz +/-0. 005% +/-56KHz with level limiting >110dB > 100dB 0. 5 "Pilotone & noiselock" dual squelch circuit 60 Hz- 18KHz 200ft
6dBpv at S/N >70dB >60dB >80dB -12db/600ohm unbalanced and balanced 12V-15VDC/0. 5A power supply 10. 8"L x 5. 9"W x 14. 2"H 1. 0kg approx
Dynamic microphone Built-in housing <10mW <-40dBC one 9V battery
---5---
---6--- [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PYLE PDWM2600
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PYLE PDWM2600 will begin.