User manual PYLE PDIW52 Install Guide

[. . . ] After you read it, put it away in a safe place for future reference. Avoid exposure of the system to rain or moisture. Handle the wireless system carefully, dropping or other shocks may cause failure. [. . . ] It may be possible to dry the system, but you should have it checked by a qualified technician before using it again. If damaged in any way, do not use the system and refer to a qualified technician for repair. If the wireless system is not going to be used for a while, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove the leakage with a damp cloth. Take care not to get battery electrolyte in contact with your skin, however if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately. When you speak into the microphone, AF signal will display on the bottom of LCD panel. 3 Using the supplied audio cable, connect from the MIXED jack socket to the "MIC IN" / "LINE IN" socket on amplifier. Alternatively, you can connect an optional XLR cable from the "XLR MIXED" socket on the receiver to a professional mixer. Connect the mains power adaptor from "DC 15V" jack to a suitable mains power socket. away from wall MIC LINE MIC LINE MIC LINE MIC LINE MIC LINE 6 The on air indicator does not light up The wireless microphone is not turned on. The AUDIO OUT on the receiver is not set correctly. Turn on the wireless microphone Turn on the microphone receiver and the connected audio equipment Turn on the microphone receiver and the connected audio equipment Replace the battery. Connect the speakers/ headphones Replace the battery. No sound The sound is distorted Adjust the volume controls. Move the wireless microphone away from the speakers or change the direction of the microphone. [. . . ] Replace the battery. The distance between the wireless microphone and speakers are too A howling noise close. Overall System Carrier Frequency: Frequency Stabilization Dynamic Range: Total Harmonic Distortion: Frequency Response: Audio Output Level: Separate Type: Mix Type: 2. [. . . ]