User manual PYLE PDCD205

[. . . ] ·Do not open the cabinet as this might result in damage to the set or electrical shock. ·When disconnecting the power cord from the AC outlet, always grasp it by the plug. ·Before moving the set, be sure to disconnect the power cord and all connecting cables. [. . . ] To memorize a 4 cue point, play then pause the disc (LED on PLAY/PAUSE blinks). You can tap this button to the rhythm of the music to get the BPM(beats per minute) value. TIME/OUTRO(Time button) This button switches the time display between elapsed playing time, track remaining time and total remain time, and also switches on off the "Outro" function. When the display shows OUTRO, the player only plays the last 30 seconds of each track. PITCH(Pitch button) When the PITCH button is pressed (PITCH LED glows), moving the fader will change the play speed up to +-16%. When it is off, moving the fader will indicate the expected play speed on the LCD, but without affecting the actual speed. PITCH BEND(Pitch Bend Button) When each of the 2 CD players is playing a CD, the pitch bend function allows the positioning of the bass beats to be matched after the pitch has been matched. The pitch will automatically rise when the + button is pressed and return to the original pitch when it is released. By changing the pitch in this way, the positioning of the beats can be matched. CONT. /SINGLE(Cont. /Single Buttons) Press these to switch between the SINGLE AUTO CUE and CONTINUOUS play modes. The selected mode is indicated on the LCD in SINGLE mode, after each track, the unit auto cues the point at which the song starts. When SINGLE AUTO CUE or CONTINUE is blinking, the unit is in relay mode. SEARCHING(Search Buttons) These buttons are used to accurately change the positions where disc play will start. CONNECTOR PORTS The 9-pin termination permits the connection of the control unit to the main unit. 5 Connections Typical connections with a mixer is illustrated below. Please use it for reference. ·Connect the connection cords to the line inputs of your mixer. [. . . ] POWER OFF TROUBLESHOOTING GUIDE If difficulties arise with your compact disc player, locate the apparent problem in the left-hand column of the table and follow the corrective action suggested in the right-hand column. Have the operating instructions for the compact disc player been followed?Symptom The power fails to switch on when the POWER switch is set to ON Disc play does not start Possible Cause Poor power plug connection at the AC outlet The disc is loaded upside down The disc is too dirty. [. . . ]