User manual PUR LINE TITANO B

[. . . ] When the dehumidifier is operating one window can be half-open but DO NOT open any more windows or doors. Leave the dehumidifier to stand for two hours before connecting to the mains supply after transport or if it has been tilted. If the power cord is damaged, it must be changed by a qualified electrician or the manufacturer to avoid any danger. [. . . ] If the power cord is damaged, it must be changed by a qualified electrician or the manufacturer to avoid any danger. The dried air then passes through a coil where it is slightly warmed end re-enters the room at a slightly elevated temperature: YOU SAVE ENERGY!As soon as your dehumidifier is « ON » it starts protecting you and your residence from the ill effects of humidity. The dehumidifier controls humidity by forcing excess moisture to condense from the air into the unit as it passes over the cooling elements. When ambient temperature decreases to 10°C, the humidity sensitive coils will be covered with frost. In this case, defrost would be ON and compressor OFF, but the fan is still working. Plug the power cord into a 230 V~ 50 Hz grounded wall outlet, then turn the humidistat knob clockwise to start the dehumidifier. CAUTION: This dehumidifier cannot be used at a room temperature below 5°C. If not use the unit for an extended period of time: - Please turn the unit off, unplug it. - Cover the unit & store where it will not receive direct sunlight. Pack your unit and the user manual in its original box and store in a cool, well ventilated place. However if the location where the unit is operating is extremely damp, you will need a few days or even weeks before you start obtain a comfortable humidity rate. The dehumidifier reduces the air humidity rate and you should notice less condensation on cold windows. Ambient temperature too low Uneven floor Wait for end of cycle Normal, will start after 3 minutes. Normal, compressor protection Install unit on a hard level surface Check with SAV Normal :refrigerant is flowing through the coils. Recommended room temperature : Dehumidification capacity : Tank capacity : Net weight : Dimensions (L x P x H) Power consumption : Input voltage Réfrigérant De 5°C à 35°C 10 l/DAY at 30°C/80 % H. [. . . ] Ambient temperature too low Uneven floor Wait for end of cycle Normal, will start after 3 minutes. Normal, compressor protection Install unit on a hard level surface Check with SAV Normal :refrigerant is flowing through the coils. Recommended room temperature : Dehumidification capacity : Tank capacity : Net weight : Dimensions (L x P x H) Power consumption : Input voltage Réfrigérant De 5°C à 35°C 10 l/DAY at 30°C/80 % H. [. . . ]