User manual PUR LINE HYDRO 6E

[. . . ] defrosting , of the reversible hot gas type , is triggered automatically by a sensor that informs the electronic board. Once defrosting is complete, the dehumidifier returns to its normal The device can therefore operate in relatively low room temperatures. Safety instructions : Please read the instruction carefully before operation. Notice : we suggest that any reparation should be executed under professional members. [. . . ] Notice : we suggest that any reparation should be executed under professional members. - Do not use the unit in the place easily affected by dust or chemicals. There should be at least one meter of empty space, free of large objects, around the dehumidifier. The device must be placed far away from any source of heat or inflammable gas. The drained water may be discharged directly into a container or outside of the room using a pipe of drainage. It is preferable not to install the dehumidifier in a very polluted or dusty location. The device must be installed in accordance with local electrical standards. The electrical plug must be connected to a circuit equipped with a 15 A fuse. the device's environment must not be polluted by corrosive gases. Note : - When displace the unit, do not slope over 45° to avoid any damaging of the compressor. Because of the accumulation of dust, the air "grill" must be cleaned regularly, at least once per month. Cleaning the Air Filter Use either a vacuum cleaner (cautiously) or soak the air filter in warm water at approximately 40° with a non-abrasive detergent, and clean it with a sponge, then rinse it. To avoid any deformation, the air filter must not be exposed to any source of heat. - Before plugging the device in again, properly return the air filter to its place and re-screw the front grill. Note : To make the filter more endurable, seal it in a plastic bag when the unit keeps power off for a long time. To keep your dehumidifier for many years, have it cleaned and its proper operations checked regularly by a professional. - If the electrical cord is damaged, it must be replaced by the installer or another qualified person. The light indicator is flashing The defrosting does not work E1 is displayed E2 is displayed The device does not want to turn on. Plugged in properly The grill is dirty The air entries and outlets are obstructed The device is placed on a slope The drain is obstructed The temperature sensor is not working The temperature sensor is loose The hygrometry sensor is not positioned properly or is defective The defrosting sensor is not positioned properly or is defective Power failure The fuse has blown The device is not plugged in properly Carefully Clean the grill Stand the device up Clean the drain Replace it Replace the temperature sensor Check the component or positioning Check the component or positioning Replace the fuse Plug the device in carefully The device does not want to turn on. If the breakdown continues, please contact your reseller or technical department. [. . . ] Plugged in properly The grill is dirty The air entries and outlets are obstructed The device is placed on a slope The drain is obstructed The temperature sensor is not working The temperature sensor is loose The hygrometry sensor is not positioned properly or is defective The defrosting sensor is not positioned properly or is defective Power failure The fuse has blown The device is not plugged in properly Carefully Clean the grill Stand the device up Clean the drain Replace it Replace the temperature sensor Check the component or positioning Check the component or positioning Replace the fuse Plug the device in carefully The device does not want to turn on. If the breakdown continues, please contact your reseller or technical department. When the dehumidifier starts or stops, the refrigeration cycle produces a specific sound. Power failure The fuse has blown The device is not Two years from the date of purchase. [. . . ]